ADEMCO 5130XM Bedienerhandbuch PDF herunterladen (Seite 88)

88 PROCRAMhfING THE SYSTEM

- 1. SELECT REPORTING FORMAT -

PRIMARY

‘46

SEC: NDARY

l 46

TRANSMISSION FORMATS

(O/l/2)

SESCOA (O-9)/

‘60

RADIONICS (O-9, Hex B-F)

W/l )

4+2 REPORTING BY ZONE ‘53

(maxlmum of 27 zones

uniquely reported)

(O/l 1

4+2 BY CHANNEL

‘54

REPORTING

;MclmUm of 15 channels)

ADEMCO CONTACT

1’32

REPORTING ENABLE

III

lol

COMMENTS: Enter selection of Ademw Low Speed format,

SESCOAIRadionics, or Ademco High Speed format as follows: 0 -

Adem& tow Speed, 1 = SESCOAIRadionics, or 2 I Ademco High

Speed for up to 15 (all 64 tt non-unique reporting is acceptable)

zoneyand 4+2 DTMF for up to 27 zones.

NOI&: If Ademco High Speed reporting is selected, the Non-Alarm

reports desired mrst be selected in Addresses

‘40, and ?61

thru ‘66

by entering any non-zero code for the desired reports.

lol

COMMENTS: Enter 0 tf Radionics tormat is to be used wtth

hexadecimal O-9, B-F repotting. Enter 1 tt SESCOA format is to be

used with only numerk reporting (O-9).

NOTE: Selection applies to both primary and

secondary phone

numbers.

lol

COMMENTS: Enter 1 if 4+2 reporting by zone for a zone expanded

system is desired, otherwise enter 0. If this reporting format is

selected, skip fields ‘51’71 and continue programming at fiild

72.

NOTE: 4+2 reporltng will only send unique reports for zones up to

27.

Zones higher than 27 wilt not be reported.

IMPORTANT!:

If Ademco High Speed format had been selected tn

Addresses ‘46 or ‘46 and thii field’s selection ts made, a high speed

4+2 transmission using DTMF/TouchTone communication can be

obtained which is compattble with Ademco No. 666 Diiital Receivers

using Level 4.3 sottware or higher.

COMMENTS: Enter 1 if 4+2 reporting is desired,enter 0 lf

3+1/4+1

or Ademco High Speed reporting is to be used. This selection is

overridden by the selection of 4+2 reporting in field ‘63. lf the 4-r-2

format of field ‘64 is selected, Fields ‘65’71 should be ptogrammed,

but fields ‘72 through ‘61 should be ski.

COMMENTS: Enter 1 to enable Ademco Contact Reporting; enter 0

to disable.

NOTE: All 64 zones and 22 users can be reported to AdenWS 666

Receiver with level 4.4 or higher software.

ADEMCO’s VISTA Xbf SERIBS TECXNICM. REFERENCE MANUAL

WWW.DIYALARMFORUM.COM

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 158 159

Kommentare zu diesen Handbüchern

Keine Kommentare

ADEMCO 5130XM Bedienerhandbuch Seite 88

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme ADEMCO 5130XM