ADEMCO 5130XM Bedienerhandbuch PDF herunterladen (Seite 85)

SECONDARY SUBSCRIBER ‘90

ACCOUNT NUMBER

(three or four PdiiH entries)

PRIMARY PHONE NUMBER ‘33

(o-9)

SECONDARY PHONE No.

(O-9)

DUAL REPORTING

(O/l 1

COMMUNICATOR SPLiT

REPORT SELECTION

(O/1/2)

DIAL TONE PAUSE

(O/l/2)

DIAL TONE DETECTION

‘34

‘51

1’34

‘42

‘43

J’ROGRAMMING TXE SYSTEM

I I I I I I I [

COMMENTS: Enter 3 or 4 diglts. Each digit requires a 2digit entry so

to allow entry of hexadecimal dig& (B-F). If a 3digit number is to

be used, only enter data in the first 6 locations, leaving the last two

unfilled. Use the chart in field ‘31 to determine the entry for each

digit. Erase the field by entering ‘90’.

NOTE: This field must be programmed ff a secondary phone number

is used (field ‘34). This acwunt number can be the same as the

primary account number.

COMMENTS: Enter up to 12 digits, O-9. Do not fill unused spaces.

Erase the field by entering ‘33’

NOTE: Back-up reporting (8 calls are made to the secondary phone

number H no acknowledgment is received after 8 attempts to the

primary number) is automatic only if there is a secondary phone

number entered.

I I I I I I-I I I I I [

COMMENTS: Enter up to 12 digits, O-9. Do not fill unused spaces.

Erase the field by entering ‘34’. If this field is programmed, a

secondary subscriber account number (field ‘90) must also be

programmed (can be the same as the primary account number).

lol

COMMENTS: Enter 1 if it is desired that all reports are sent to both

primary and secondary phone numbers. If dual reporting is desired

and Ademw High Speed format is to be used at all, it must be

selected as both the primary and secondary transmission formats.

NOTE: Dual reporting cannot be used if Split reporting is selected in

field 1’34.

COMMENTS: Enter 0, 1, or 2, in accordance with the following:

0 = split reporting disabled; 1 = alarm, alarm restore 8 cancel reports

sent to primary Teiw number, ail others to secondary Telco number;

2 = open/close 8 test reports sent to secondary Teico number and ail

other reports to primary.

lol

COMMENTS: Enter the desired wait time for dial tone detection as

follows: Enter single digit, 0 = 5 seconds:

1 =

11 seconds; or 2 = 30

seconds.

COMMENTS: Enter

if true dial tone detection is desired. Enter 0 if

only a delay before dialing (same as programmed in field ‘42) is

desired. The latter may be necessary in high-noise environment

Teiw networks where noise can be confused with dial tone, resutting

in premature dialing.

ADEMCO’s VISTA XM SERIES TECHNICAL REFERENCE MANUAL

WWW.DIYALARMFORUM.COM

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 158 159

Kommentare zu diesen Handbüchern

Keine Kommentare

ADEMCO 5130XM Bedienerhandbuch Seite 85

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme ADEMCO 5130XM