ADEMCO 5130XM Bedienerhandbuch PDF herunterladen (Seite 43)

- 0.

PASSIVE INFRARED MOTION DETECTORS -

GENERAL

INFORMATION

POLLING LOOP

(4196)

SYSTEM CONFIGURATION (PERIPHERALS)

4 3

Select a mounting site with the following notes in mind: Best coverage will be

obtained if the mounting site is selected such that the likely direction of

intruder motion is across the pattern of protection.

Avoid locating the unit where central heating radiators, flames or heating

outlet ducts are within the protective zones.

Avoid locating the unit in direct sunlight or directly above strong sources of

heat.

Avoid locating the unit on unstable surfaces.

Avoid running alarm wiring close to heavy duty electrical cables.

Make wire connections as shown:

PIR

The 4196 is a quad element passive infrared detector with a buitl-in RPM that

is connected directly to the- polling loop. It provides up to 40 feet of

protection, using a wide angle mirror, or up to 70 feet of corridor protection

using the long range mirror (both mirrors are provided with the unit). A right

zone is available for use with closed-circuit devices and can be programmed

for a different zone type than the PIR. The 4196 can be flat wall mounted or

comer mounted, using the mounting plate provided. Programming of the

unit’s address ID is accomplished via the units DIP switches (see Table 1 in

the preceding section). Refer to the instructions accompanying the 4196 for

patterns of coverage and procedures for changing mirrors.

4196 PIR W/BUILT-IN RPM

LiiFEl

WIDE ANGLE LONG RANGE

MIRROR

(SET FOR ID NO. 8)

THIS RIGHT LOOP IS ALWAYS

NORMALLY CLOSED, UNSUPERVISED!

DO NOT USE EOLR!

Diagram 24. 4196 POLLING LOOP PIR

ADEbfCO’s VISTA XM SERIES TECtjlNICAL REFERENCE MANUAL

WWW.DIYALARMFORUM.COM

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 158 159

Keine Kommentare

ADEMCO 5130XM Bedienerhandbuch Seite 43