ADEMCO 5130XM Bedienerhandbuch PDF herunterladen (Seite 27)

SYSTEM CONFIGIfRAl7ON (ZONES)

2 7

The 4190WH is a O-zone (known as left and rtght zones) RPM. The lett zone

can be used tor cbsedcimult devices, with or without EOLR supervision.

and

for open-circuit devices, with EOLR supervision. The left zone can also be

used wlth fast-response (10 millisecond) devices, if necessary. Follow the

chart below for cutting the correct jumpers and choosing the correct resistor

when using the left zone.

The right zone is for closed-circuit, unsupervised use only, and has a

response time of 400 milliseconds. Do not cut any jumpers or use a resistor

on this zone.

JUMPFRS

USACj&&EFT Zu ONI Y\

RED: Cut tar fast-response (10 millisecond).

WHITE: Cut tar low current mode (reed type switches); use the

30,000 ohm resistor, provided. Must be cut if BLUE jumper is

cut.

BLUE: Cut tor use with no EOLR (closed-circuit only). Doing this

automatically puts an internal 30,000 ohm resistor in series

with the zone, so

the white jumper must also be cut.

NONE CUT: High current mode: Use the 4.700 ohm resistor, provided,

with mechanical switches in either an open-circuit or closed-

circuit configuration.

EXPLODED VIEW

SE-KING UP A 4190WH

ALWAYS OBSERVE POLARITY.

ALWAYS CONNECT IN PARALLEL.

. SEE TEXT FOR WIRE GAUGE AND

WIRE LENGTH REQUIREMENTS.

Diagmm 7. 4190WH LEFT/RIGHT ZONES

RIGHT LOOP: FOR N.C. SERIES

CIRCUITS ONLY. USE SEALED

(REED) CONTACTS.

LEFT LOOP: FOR N.C. CIRCUIT

(INTERNAL EOLR) OR N.C.

AND/OR N.O. CIRCUIT (UCTER-

NAL EOLR).

ADEMCO’s WSYA XM SERIES TECHNICAL REFERENCE MANUAL

WWW.DIYALARMFORUM.COM

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 158 159

Keine Kommentare

ADEMCO 5130XM Bedienerhandbuch Seite 27