60
SYSTEM OPERATION
CHIME MODE
(CODE + CHIME)
VIEWING MESSAGES
FROM THE
CENTRAL STATION
USING THE BUILT-IN
USER’S GUIDE
DISPLAYING
DESCRIPTORS
_-
PANIC KEYS
The system can be set to annunciate any opening of entry/exit or perimeter
zones (doors, windows) while the system is disarmed. Enter the security
zone and press the CHIME key. Repeat to turn chime mode off.
For 513OXM or 414fIXM with 5137 consoles only.
Users may occasionally receive messages on the console display from their
central monitoring station. When this occurs, the console will display
‘Message. Press 0 for 5 sets.‘. Instruct the user to press and hold the 0 key
to display the central station’s message. Note that the system must be in the
READY state to view these messages.
For 5130XM or 4140XM with 5137 consoles only.
An abbreviated Use6 Manual is stored in the system’s memory, and can be
particularly useful to the end user if the printed User’s Manual is not
conveniently accessible when the user needs to perform a seldom used and
unfamiliar system procedure. The Built-in User’s Guide is displayed by simply
pressing any of the function keys (e.g., OFF, AWAY, STAY, MAXIMUM,
BYPASS, INSTANT, CODE, TEST, READY, #, and CHIME) for approximately
5 seconds and then releasing it. Abbreviated instructions relative to the key
that has been pressed will then be displayed (2 lines of text are displayed at a
time). This function is available when the system is in the armed or the
disarmed state.
For 5130XM or 4140XM with 5137 consoles only.
The Alpha Consoles can display all programmed descriptors, which is useful
to the installer when checking entries, and can be helpful to the user when
there is a need to identify zones. To display descriptors, press and hold the
READY key until the built-in instructions for that key appear, then release the
key. The zone descriptors will appear one at a time, for about 2-3 seconds
each. For faster viewing, press the READY key to display the next descriptor
in numerical order and so on. When all descriptors have been displayed, the
Control will exit display mode. To exit display mode before all descriptors
have been displayed, enter tne security code and press the OFF key.
There are three pairs of keys (I’ + 11, [# + 31, [’ + #]) that, if programmed, can
be used to manually initiate alarms and send a report to the central station.
Each pair of keys can be individually programmed for 24 Hour Silent, Audible
or Auxiliary (Emergency) responses. The panic function is activated when the
appropriate pair of keys are pressed at the same time. Refer to the ZONE
DEFlNlTlONS section for additional information regarding these functions.
The panic functions are identified by the system as follows:
pqF
For 5130XM14140XM wfth 5137 consoles, these panic keys can also be
programmed with an alpha descriptor.
IMPORTANT: For the Panic functions to be of practical value, the system
must be connected to a central station.
ADBMCO’s VISTA Xbf SERIES
TECHNICAL
REFERENCE MANUAL
WWW.DIYALARMFORUM.COM
(8 Seiten)
(173 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern