ADEMCO Vista-128FB Einstellungsanleitung PDF herunterladen (Seite 88)

VISTA-128BP/VISTA-250BP Installation and Setup Guide

5-14

2*21

Supervision Pulses for LRR

0 = disable

1 = enable

There are three entries in this field as follows: Fire, Burglary/Audible Panic,

Silent Panic/Duress.

If enabled, causes the control to send periodic short pulses on the J7 radio

triggers to the LRR. The LRR uses these pulses to determine that its

connection to the control is still intact.

Must be 1 for UL installations.

2*22

Display Fire Alarms of Other

Partitions (partition-specific)

0 = disable

1 = enable

If enabled, allows fire alarms that occur on other partitions to be displayed at

this partition’s keypad(s).

2*23

Display Burglary & Panic Alarms

for Other Partitions (partition-

specific)

0 = disable

1 = enable

If enabled, allows burglary and panic alarms that occur on other partitions to be

displayed at this partition’s keypad(s).

2*24

Display Troubles of Other

Partitions (partition-specific)

0 = disable

1 = enable

If enabled, allows troubles that occur on other partitions to be displayed at this

partition’s keypad(s).

2*30

Pager Installed

0 = disable

1 = enable

Enable if the alphanumeric pager interface is installed.

2*31

Delay Paging

0 = disable

1 = enable

This field has eight locations, one for each pager. If enabled, the system waits

the delay time specified in field 2*32 before transmitting the message after the

dialer completes sending the message.

2*32

Time to Delay Pager After Dialer

000-024 times 10 seconds (010-240).

This delay should be set to allow enough time for the central station to call back

the premises in order to verify an alarm condition. Field 2*31 must be enabled.

2*33

Pager 1 Phone Number

Enter 0-9; #11 for *, #12 for #, #13 for a 2-

second pause.

Enter the paging service phone number for Pager 1. Enter up to 17 digits. Do

not fill unused spaces.

2*34

Pager 1 ID Number

Enter 0-9

Enter the Pager ID number for Pager 1. Enter up to 10 digits.

2*35

Pager 1 Format

0 = numeric

1 = ID

2 = alphanumeric

Enter the pager format for Pager 1.

2*36

Pager 1 Delay 1

000-060 seconds.

This delay occurs after the phone number is dialed and before the pager ID is

sent, giving the pager system time to answer the phone call.

NOTE: Program only if using numeric format.

2*37

Pager 1 Delay 2

000-060 seconds.

This delay occurs after the pager ID is sent and before the event information is

sent.

NOTE: Program only if using numeric format.

FIELD

TITLE and DATA ENTRIES EXPLANATION

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 146 147

Kommentare zu diesen Handbüchern

Keine Kommentare

ADEMCO Vista-128FB Einstellungsanleitung Seite 88

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme ADEMCO Vista-128FB