ADEMCO Vista-128FB Einstellungsanleitung PDF herunterladen (Seite 40)

VISTA-128BP/VISTA-250BP Installation and Setup Guide

3-18

3 Connect the module to the control’s keypad

terminals (6, 7, 8, and 9).

00000

ECP Bus

Dip Switch

Optional

Keyswitch

Connection

SIDE

VIEW

All Switches shown

in Up position.

(ECP Address 23)

Terminal

Block

Connect to

Keypad

Terminals

Figure 3-23: Wiring the FSA Module

Installing 4101SN Relay Modules

The 4101SN V-Plex Single Output Relay Module is a

serial number polling loop output device. The 4101SN

features the following:

• Form C relay contacts rated at 2A, 28VAC/VDC

with contact supervision.

The position of the relay is supervised, but not

the actual external contact wiring.

• One class B/style B EOLR-supervised auxiliary

input zone.

• Operating power and communication with control

panels via the V-Plex polling loop.

• Electronics mounted in a small plastic case with

tamper-protected cover.

Connect the device to the polling loop, terminals 24 (+)

and 25 (-). Be sure to observe polarity

Installing X10 Devices

X-10 devices are either plugged into standard AC

outlets or wired into the AC electrical system by a

licensed electrician, depending on the type of device

used.

Note each device’s House and Unit Code

setup, as these codes will be used to program

the devices in

Output Programming

#93

Menu Mode

described in the

Programming

Guide

X-10 devices require the use of a 1361X10 transformer

in place of the regular 1361 transformer.

X-10 devices respond to “on” and “off” commands sent

from the panel through the 1361X10 transformer.

To connect the 1361X10 transformer, see Connecting

the Transformer, later in this section.

Installing the Ground Start Module

The Ground Start Module is not intended for

use in UL Listed applications.

Output 1 may be used to trigger an optional 675

Ground Start Module for installations having

telephone lines that require ground start instead of

loop start operation to obtain a dial tone from the telco

central office.

When the panel has a message to transmit to the

central station, it seizes the line, goes off hook, and

then triggers the 675 Module to connect the RING side

of the telephone line to earth ground. The panel

causes the module to break the connection between

RING and earth ground when it obtains a dial tone.

You cannot use Output 1 for the Ground Start

if you are using it for a Smoke Detector Reset

or an AAV module.

To install the 675 Ground Start Module, perform the

following steps:

Step Action

1 Determine which side of the telephone line

is the RING side by connecting the (+) lead

of a DC voltmeter to earth ground, and the

(-) lead to one side of the telephone line.

The wire that reads + 50VDC is the

RING side.

2 Connect the 675 Ground Start Module to

the panel’s J7 connector trigger output 1,

to auxiliary power, and to the RING side of

the telephone line as shown in Figure 3-24.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 146 147

Kommentare zu diesen Handbüchern

Keine Kommentare

ADEMCO Vista-128FB Einstellungsanleitung Seite 40

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme ADEMCO Vista-128FB