ADEMCO 4140XMPT2 Bedienungsanleitung PDF herunterladen (Seite 74)

– 74 –

Creating A Custom Message Display (Installer's Message)

Normally, when the system is in the disarmed state, the following display is

present on the Console.

****DISARMED****

READY TO ARM

Part or all of the above message can be modified to create a custom installer

message for each partition. For example, ****DISARMED**** on the first line

or READY TO ARM on the second line could be replaced by the installation

company name or phone number for service. Note that there are only 16

character spaces on each of the two lines. To create a custom display

message, proceed as follows:

1. Select DEFAULT SCREEN mode. The console will ask for the partition

number for this message. Enter the partition number. Press [*] to accept

entry.

The following will appear:

****DISARMED****

READY TO ARM

A cursor will be present at the extreme left of the first line (over the first "star").

The [6] key is used to move the cursor to the right and the [4] key to move the

cursor to the left. Key [7] may be used to insert spaces or erase existing

characters.

2. For example, to replace READY TO ARM with the message SERVICE:424-

0177, proceed as follows:

Press the [6] key to move the cursor to the right, and continue until the cursor

is positioned over the first location on the second line.

Press the [3] key to advance through the alphabet to the first desired

character (in this case, "S"). Use the [1] key to go backward, when necessary.

When the desired character is reached, press [6]. The cursor will then move

to the next position, ready for entry of the next character (in this example,

"E"). When the cursor reaches a position over an existing character, pressing

the [3] or [1] key will advance or back up from that character in the alphabet.

Proceed in this manner until all characters in the message have been

entered.

3. To store this new display message in memory, press the [8] key.

4. The system will ask for a new partition number. Enter 00 to quit or 1-8 for a

new partition number.

Creating Relay Descriptors

Select relay descript mode. The system will ask for the relay number desired.

Enter 01-16 (00 to quit). Follow the same procedure as for CUSTOM WORDS.

Relay descriptors may have up to 10 characters.

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 131 132

Keine Kommentare

ADEMCO 4140XMPT2 Bedienungsanleitung Seite 74