ADEMCO 4140XMPT2 Bedienungsanleitung Seite 30
- Seite / 132
- Inhaltsverzeichnis
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
– 30 –
START STOP
ACTION DESIRED A E V Z L Z T P Z L Z T P
=You must define a Start zone list (zl) for these
applications to work properly.
*Can be used to turn on lights in a specific room or area.
For example you can automatically turn on the basement
light on entry.
CHIME
Close relay for 2 seconds during chime. (Chime mode
must be turned on at control)
10038X000X
Chime on Specific zones:
Zones in zone list (x) close relay for 2 seconds on faults* 1 2 X 00 X 0 00 X
*Will activate relay for any zone type plus panics on 5801
whether control is armed or disarmed. (Console panics will
not activate a relay with the configurations above.)
Zones in zone list (x) close relay for 2 seconds on alarms 1 1 X 00 X 0 00 X
Zones in zone list (x) close relay for 2 seconds on troubles 1 3 X 00 X 0 00 X
BELL OUTPUT
Zones in zone list (x) close relay on alarms and reset at bell
timeout or when disarmed by any either partition.
2 1 X 00 X 0 36 X
Zones in zone list (x) pulse relay on alarms and reset at
bell timeout or when disarmed by any partition.
31X00X036X
Close relay after any burglary alarm and reset when
disarmed by any partition.
2 0 0 33 X 0 22 X
Close relay after any burglary alarm and reset at bell
timeout or when disarmed by any partition.
20033X036X
*Response types 06,08, and 09 will not activate relay. If
PULSE relay is desired, enter a 3 in A(action).
STROBE LIGHT
Zones in zone list (x) close relay after alarms and reset
when disarmed by either partition. (Latching relay for
strobes)*
2 1 X 00 X 0 22 X
Zones in zone list (x) pulse a relay after alarms and reset
when disarmed by either partition.*
31X00X022X
*Relay will activate for burglary, fire, and panic alarms if
programmed into zone list.
Zones in zone list (x) close relay on alarms and reset with
key entry of security code + # + 7 + 1
2 1 X 00 X 0 34 X
SYSTEM STATUS INDICATORS
Close relay when ARMED-AWAY, reset when
DISARMED. (Any partition)*
20021X022X
Close relay when ARMED-STAY, reset when DISARMED.
(Any partition)*
20020X022X
*If PULSED relay is desired, enter a 3 in A(action).
Bypassing a zone causes relay to close and will reset with
a disarm sequence (code + off.)
20040X022X
CONFIRMATION OF ARMING DING
Close relay for 2 seconds at end of exit delay time after
system is armed
10031X000X
- 4140XMPT2 1
- CONGRATULATIONS! 2
- TABLE OF CONTENTS 3
- INSTALLATION INSTRUCTIONS 6
- SUMMARY OF SYSTEM FEATURES 7
- SCHEDULING OVERVIEW 12
- BASIC 9 HARD-WIRED ZONES 15
- Wire Gauge Max. Length 17
- J7 CONNECTOR 25
- 4142TR CABLE 25
- 1 2 3 4 5 6 7 8 9 26
- IST OF START 29
- URN ON LIGHTS 29
- ELL OUTPUT 30
- TROBE LIGHT 30
- YSTEM STATUS INDICATORS 30
- ONFIRMATION OF ARMING DING 30
- NLOCK EXIT DOORS 31
- URN ON EMERGENCY LIGHTING 31
- OUNDING FOR WIRELESS KEYPAD 31
- Section 3 32
- REMOTE CONSOLES, SOUNDERS 32
- & PHONE CONNECTIONS 32
- Wire Gauge Maximum Length 33
- EXTERNAL SOUNDERS 34
- PHONE CONNECTIONS 34
- Section 4 35
- POWERING THE SYSTEM 36
- (total poll loop worksht) 37
- Section 7 39
- Section 8 41
- PROGRAMMING GUIDE 42
- 00-15; 00=no suppression 43
- RF Trans. Type 46
- Section 2 50
- INDEX TO PROGRAMMING FIELDS 53
- DATA FIELD DESCRIPTIONS 54
- (refer to #93 and 60
- — 61 — 61
- Selected Partitio 61
- Set of Fields 61
- — 63 — 63
- 2nd Page Fields 63
- ALPHA VOCABULARY 75
- CHARACTER (ASCII) CHART 75
- COMMUNICATION FORMATS 76
- Code Definition 78
- COMMUNICATION PROGRAMMING 79
- NOTES Note: Low Speed will 80
- Section 6 DOWNLOADING 85
- DIRECT WIRE DOWNLOADING 87
- INTRODUCTION TO SCHEDULING 88
- Note that 00 is 89
- #80 SCHEDULING MENU MODE 92
- Number (HH:MM) (HH:MM) 93
- Hol. Partition 94
- Mon/Day 1 2345678 94
- HOLIDAY NUMBER ? 99
- Action Codes: 100
- 01 RELAY GRP # ? 100
- GROUP ? 12345678 100
- ACCESS SCHED # ? 101
- MON A1 Window 1? 101
- MON A3 Window 2 ? 101
- Hol A1 Window 1 ? 101
- Hol A1 Window 2 ? 101
- #83 USER SCHEDULING MENU MODE 104
- SYSTEM OPERATION 105
- Section 1. SYSTEM OPERATION 106
- User 3 User 5 108
- Level 1 Level 4 108
- Master Oper B 108
- KEYPAD FUNCTIONS 111
- Part. 1 WHSE 112
- User 01 Auth.=1 112
- PRINTER DTR 114
- BYPASS EVENT LOG 115
- SYSTEM EVENT LOG 115
- DIP SWITCH POSITION 121
- 4275EX PIR 122
- 4194 REED CONTACT 122
- (SURFACE MOUNT) 122
- 4278EX PIR 122
- IMPORTANT 123
- SET SWITCHES WITH 123
- BATTERY REMOVED 123
- Section 6. SPECIFICATIONS 124
- WARNING! 130
- RINGER EQUIVALENCE: 0.7B 131
- © 1996 PITTWAY CORPORATION 132
Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme ADEMCO 4140XMPT2
(88 Seiten)
(61 Seiten)
(132 Seiten)© 2020, manymanuals.de. Alle Rechte vorbehalten. | 0.050 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern