ADEMCO 4140XMPT2 Bedienungsanleitung PDF herunterladen (Seite 38)

– 38 –

Section 6. SETTING THE REAL-TIME CLOCK

Procedure

Important:

This method is

different from the

previous method of

setting the clock.

NOTE: A 6139 alpha console must be used to set the real-time clock, or the clock

can be set via the Downloader software. Only users with installer or master

authority level can set the real-time clock.

To enter real-time clock mode, enter installer or master code + #63. A

typical display will show:

TIME/DATE – THU

12:01 AM 01/01/90

The day of the week is automatically calculated based on the date entered. Time

and date entries are made by simply entering the appropriate hour, minute,

month, day and year. Pressing the [*] key accepts the entered value and moves

the cursor to the right. Pressing the [#] key moves the cursor to the left of the

display, to the previous position.

To set the time and date, simply enter the correct hour then press [*] to

move to the minutes and make the correct entry.

Press [*] again, then toggle the AM/PM by pressing any key 0-9.

Press [*] to move cursor to the month position and enter the correct month using

a 2-digit entry.

Press [*] and enter the correct date.

Press [*] and enter the correct year.

To exit clock mode, press the [*] key after the cursor is in the year position.

NOTE: The real-time clock can be synchronized to either 50Hz or 60Hz mains by

the selection in program field 1*56. Failure to select the correct power source will

result in inaccurate drifting of the time.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 131 132

Keine Kommentare

ADEMCO 4140XMPT2 Bedienungsanleitung Seite 38