ADEMCO Accord Installationshandbuch PDF herunterladen (Seite 54)

Zone Type Definitions

General Information

The Accord xpC has ten zone types, these are:

0 — Not Used

Zones which are unused should be programmed as 0 Not Used. These zones should

also be linked out using the appropriate zone link or 1K resistor provided in the

Auxiliary pack.

1 — Final Exit

The Final Exit zone is used for the entry/exit route(s), usually assigned to the front

door or other main entry point(s). The zone becomes operational when the system is

set or setting.

The Exit Time must be set to infinite (410) for a Final Exit zone to terminate a Full

Setting procedure.

Activation of a Final Exit zone while the system is set, initiates the unsetting proce-

dure. The keypads beep and all Intermediate Exit Zones are isolated. A valid User

Code must be entered at the keypad or a Keyswitch Zone activated before the Entry

Time has elapsed. The Exit Time is fixed at 30 seconds when the system is Part Set or

Night Set then.

2 — Keyswitch

A Keyswitch zone has a latching operation.

The Keyswitch should be wired across the zone terminals to Full Set the system.

Opening the Keyswitch zone will start the Full setting procedure. Closing the

Keyswitch zone (closed circuit) instantly unsets the system.

The Keyswitch can also unset the system from Part or Night Set when programmed in

group 2 and 3.

It is strongly recommended that the Keyswitch should be fitted in a Tamper protected

case with the Tamper switch connected in series with the other Tamper circuits at the

control panel.

3 — Intruder

An Intruder zone is used on devices that require an instant alarm if activated when the

system is Set. During the Set state, zone activations cause internal sounders and

external sounders to activate.

4 — Walk Through

A Walk Through zone is used with the Final Exit zone. The unsetting procedure is

initiated, all Walk Through zones are omitted during the Entry Time when the system

is set and a Final Exit zone is activated. This gives users access to a keypad or

keyswitch.

If a Walk Through zone is activated first when the system is Full Set it causes a full

alarm.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 77 78

Keine Kommentare

ADEMCO Accord Installationshandbuch Seite 54