ADEMCO Accord Installationshandbuch PDF herunterladen (Seite 44)

Group 7 — Option 2 Dial Type

If this option is set to 0 the panel dials using Pulse dialling, also known as Rotary or

Loop Disconnect

If this option is set to 1 the panel dials using DTMF Dial, also known as Tone.

Note: Although this equipment can use either Pulse or DTMF dialling, only the

performance of the DTMF signalling is subject to regulatory requirements for

correct operation. It is therefore recommended that the equipment is set to use

DTMF dialling.

This option defaults to 1 (DTMF).

Group 7 — Option 3 Prevent Full Set if Line Fail

If disabled (0) the panel can be full set if a Line Fail has been detected.

If enabled (1) the panel can not be full set if a Line Fail has been detected.

This option defaults to 0 (disabled).

Group 7 — Option 4 Bell Delay

If this option is disabled (set to 0) there is no Bell Delay.

If this option is enabled (set to 1) there is a 10 minute delay between an alarm and the

activation of internal and external sounders. During this time the entry beeps sound if

the unsetting procedure is initiated and the Bell Delay is overridden if a Line Fail or

Comms Fail condition occurs.

This option defaults to 0 (no Bell Delay).

Note: Bell Delay is over-ridden in set states that are not programmed to

communicate (Group 7 - Option 6).

Group 7 — Option 5 Exit Terminate

If Push-to-Set is enabled (options 1 – 4), Full, Part or Night set exit times for the

selected will be set to infinity. For Full Set this overrides the value programmed in the

Exit Time option (Group 4 System Options — Option 1 Exit Time).

Setting of the system is terminated when a Push-to-Set zone is opened during the exit

time. There is a five second delay between the closing of the Exit Terminate zone and

the setting of the system.

Note: The operation (opening and closing) of Exit Terminate zones has no effect on

the system except during the setting procedure.

The options for Push-to-Set are:

0. Push-to-Set not used.

1. Push-to-Set on Full Set only.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 77 78

Keine Kommentare

ADEMCO Accord Installationshandbuch Seite 44