ADEMCO Accord Installationshandbuch PDF herunterladen (Seite 15)

Section 2: Installing the Accord XPC

Ancillaries Pack

The Accord xpC control panel comes with an ancillaries pack. It contains ten zone

links, a cable clamp (with two self tapping screws), two M4×20 mm lid screws,

battery connector leads and 16, 1K resistors.

Initial Mounting

Use the keyhole slot in the enclosure base to position the control panel enclosure.

Three mounting screws (not provided) are required to mount the enclosure base. Fix

one of the screws into the mounting surface, this will be used for the top, keyhole

mounting hole. Hang the enclosure base onto the mounting screw ensuring that the

screw sits in the narrow portion of the keyhole.

All cables should be brought into the enclosure base via the cable entry points shown

in figure 2.1. There are six cable entry holes for the entry of alarm cables. There is

one a.c. mains cable entry point located below the mains terminal block.

Figure 2.1 Accord XPC Enclosure Layout

Note: Leave about 60 mm above the control panel enclosure to enable the enclosure

lid to move on its hinges for removal and replacement.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 77 78

Keine Kommentare

ADEMCO Accord Installationshandbuch Seite 15