ADEMCO Accord Installationshandbuch PDF herunterladen (Seite 57)

Section 4: Wire Free Installation

Instructions

6128RFH Keypad and 5882H Receiver Installation

Receiver Types

The following notes cover the installation of the radio receiver to the Accord panel,

which allows the panel to receive the signals from the 5800 series wire free detectors.

There are two types of receiver that can be used. Only one receiver should be con-

nected to any one panel.

1. Rf devices can be used on panels with software version 1.40 or higher.

2. The 6128RFH keypad combines a keypad and a radio receiver in one housing.

A mix of keypad types is permissible on the Accord xpC.

3. The 5882H is a stand alone radio receiver. An additional standard keypad

needs to be connected to the Accord panel when using the 5882H receiver.

Mounting

Both the 6128RFH keypad and 5882H receiver are supplied with mounting and fitting

instructions. Please refer to these for full details.

Wiring

Cabling to the 6128RFH keypad and 5882H receiver can be routed through the

openings in the back of the casing or via the knockouts if required. Please note that all

cabling should be kept clear of the antenna as this could reduce the performance of the

receiver. The wiring connections between the 6128RFH keypad, the 5882H receiver

and the Accord xpC panel are as detailed below.

6128RFH: Wire from the screw terminals on the rear of the PCB directly to the

Control panel as per Table 4-1 below.

5882H: The receiver comes with a five way flying lead which should first be plugged

into the socket on the bottom left of the PCB as viewed from the rear. The coloured

cables should be connected direct to the control panel as per Table 4-1 below. Please

note that the blue wire is not used and may be cut off.

dapyeKHFR8216daeLno-gulPH2885lenaPCpxdroccA

+deR+XUA

-kcalB-XUA

ODwolleYODDAPK

IDneerGID

Table 4-1 Keypad/Receiver Wiring

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 77 78

Keine Kommentare

ADEMCO Accord Installationshandbuch Seite 57