ADEMCO Accord Installationshandbuch PDF herunterladen (Seite 35)

Assistance: Press 4+6 together. Keypad displays scrolling LEDs ( ) with fast pulse

tone.

Fire: Press 7+9 together. Keypad displays scrolling LEDs ( ) with slow pulse tone .

Panic: Press Ö and # together. All LEDs (PA) illuminate and a constant tone emits.

Buttons must be held down for two seconds for Hotkey Operation.

This option defaults to 0 (disabled).

Note: For important information on Ö and # key operation see the note in “An

Introduction to Programming the Accord xpC”.

Group 5 — Option 5 Auto Omit Keypad

When enabled (set to 1) the keypad is omitted if 20 keys are pressed without a valid

code being entered, this does not include the # key. The keypad is omitted from the

system for 10 minutes and affects all keypads on the system. Keypad auto omit is

indicated by flashing zone LEDs (– –) on the keypad.

A keypad auto omit may be cancelled by operating a zone programmed as Keyswitch.

This option defaults to 0 (disabled).

Group 5 — Option 6 Bell Output

When set to 0 the Bell output is negative applied (positive removed).

When set to 1 the Bell output is negative removed (positive applied).

This option defaults to 0 (negative applied).

Group 5 — Option 7 Alarm Trigger Output

When set to 0 the Alarm Trigger output is negative applied (positive removed).

When set to 1 the Alarm Trigger is negative removed (positive applied).

This option defaults to 0 (negative applied).

Note: Only valid when Alarm trigger Output (Group 4 - Option 7) is set to 3.

Group 5 — Option 8 System Reset for Day Tampers

This option determines how the system may be reset after a tamper condition that

occurs when the panel is unset and has four modes:

0. Customer.

1. Engineer.

2. Technistore.

3. Engineer or Technistore.

Set to 0 (Customer): User code resets the system after day tamper activations.

Set to 1 (Engineer): User code can cancel a day tamper activation but the engineer

code is required to reset the system.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 77 78

Keine Kommentare

ADEMCO Accord Installationshandbuch Seite 35