ADEMCO 4120XM Betriebsanweisung PDF herunterladen (Seite 55)

1●33 Touchstone

Enter 1 to enable Rotary back-up if communicator is not successful on dialing

W/Rotary Backup

using TouchTone DTMF on first attempt. Enter O if this option is not be to be

(Q=no/l=yes)

used.

1.34 communication

Enter O, 1, or 2, in accordance with the following:

Split Report

O= split reporting disabled; 1 = alarm, alarm restore& cancel reports sent to

Selection

primaty Telco number, all others to secondary Telco number 2 = operdclose &

(Q/1/2)

test reports sent to secondary Telco number and all other reports to primary. See

*51 for spliffdual reporting comments.

1●35.1 .39 Not Used

1●4O Armed Stay Dialer The dialer can be made to send a report

when the system is armed in the STAY

Report (First Digit)

mode,as follows:

If any Low Speed reporl is beong used, the report codes are assigned in this 2-

digit field (and field 1*41 below), which is similar to programming a

CLOSE report

in fields ●81 and ●82.

If Ademco High Speed format is being used, a normal closing report will be sent.

If Ademco Contact ID is used, a new code, R441, will be sent. Note

that 685

receivers that do not have software revision 4.5 or higher will print an error

message in place of the English text.

1●41 Armed Stsy Dialer

See

Field 1●40,

Report (Second

Digit)

1,42.1 ●43 Not Used

1*44 RF Keypad Tamper

Enter 1 to enable tamper detection on wireless keypad. Enter O if tamper

Detect

detection is not desired. If this feature is enabled, any attempt to tamper by

(Q=no/l=yes)

means of many trial entries at a wireless keypad will be blocked by the control

panel. If more than 40 key depressions are received without a valid sequence

(arm, disarm, etc.), the Control panel will disable the wireless keypad. The inhibit

is removed once a valid key sequence is received from a wired keypad.

1.45 Console

Enter 1 if beeps from the consoles during exit delay is desired. Enter Ofor no

Annununciation

console sound during exit delay.

During Exit Delay

(Q=no/1=yes)

1*46

Auxiliary Output

Enter Oif ground start output is required; enter 1 if the TERMINAL 9 output will be

Enable

used to produce an operdclose trigger, 3 if zone 1 is to use EOLR supervision.

(ollf~

“2” is unused.

NOTE: Onlv one of the above oDtions can be active within a svstem.

1*47 Chime

Enter 1 for chime annunciation using the external alarm sounder (if not desired,

Annununciation On

enter O).

External Sounder

(Q=no/l=yes)

1*48 Wireless Keypad

Enter 1 if wireless keypad is not to be used (disable keypad). Enter Oif wireless

Disable

keypad is used.

(Q=no/1=yes)

1s49 DisabIe Trouble

Enter 1 to disable trouble sounding for transmitter check-in failure; enter O if

Sounder For

audible trouble sounding is desired. Must be “O”for UL.

Supervision

(O=no/l=yes)

1*5O Babysitter Code Enter 1 if it is desired that User 22 cannot disarm the system unless the system

(Q=no/1=yes)

was armed by User 22.

-55-

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 79 80

Kommentare zu diesen Handbüchern

Keine Kommentare

ADEMCO 4120XM Betriebsanweisung Seite 55

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme ADEMCO 4120XM