ADEMCO Security System VISTA-15CN Einstellungsanleitung PDF herunterladen (Seite 82)

VISTA-15/VISTA-15CN Installation and Setup Guide

16–6

10 XMIT TO CONFIRM

PRESS

✱

TO SKIP

The prompt to confirm appears.

This prompt appears only if you

asnswered “Yes” to the SET TO CONFIRM? prompt at the

bottom of page 16-4. To confirm, activate the loop input or button

that corresponds to this zone.

The system checks for a duplicate. If a duplicate exists, a long

error beep sounds.

Press [#] to back up and re-enter the serial and/or loop number.

If Serial or Loop

Numbers do not match

after activating the

transmitter

→

If the serial/loop number combination transmitted does not match

the serial and loop number entered, a display similar to the one

below appears. If the loop number does not match, it is also

displayed.

Keyd A022-4063

Rcvd A022-4064 1

If so, activate the transmitter’s loop input or button one or more

times.

If a match is still not obtained (i.e., summary display does not

appear), press the [#] key twice and enter the correct loop input

or, if correct, press [#] again and then enter the correct serial

number.

Zn ZT RC In:

11 00

10 RF:

Note that when editing, an “s”

next to the loop number indi-

cates that the transmitter’s

serial number has been

enrolled.

If the serial number transmitted matches the serial number

entered, the keypad beeps 3 times and advances to the Summary

display of the next zone to be programmed.

NOTE: Following the successful enrollment of each wireless device, remove ONE of the

serial number labels from the device and affix it in the appropriate column on the

ENROLLED TRANSMITTERS worksheet of the Programming Form; then enter the other

information (zone number, zone type, loop number, etc.) relevant to that device. This

information would be useful if any troubleshooting is needed later on. The installer may want

to consider leaving this worksheet at the site (in the panel cabinet).

To Remove a Zone

To either temporarily or permanently remove a zone from the system (5800 system):

1. Enter the programming mode:

Key Installer Code + 8 + 0 + 0 and press

✱

56.

2. The following display appears:

SET TO CONFIRM?

0 = NO 1 = YES 0

Enter 0 for No; 1 for Yes.

3. The following display appears:

Enter Zn Num.

(00 = Quit) 10

Enter zone number to be removed. Example: 10.

Press [

✱

] to continue.

Zn ZT RC In:

10 03

10 RF:

This summary display appears.

Press [✱] to continue.

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 131 132

Kommentare zu diesen Handbüchern

Keine Kommentare

ADEMCO Security System VISTA-15CN Einstellungsanleitung Seite 82

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme ADEMCO Security System VISTA-15CN