ADEMCO Accord Spezifikationen

iINSTALLATION INSTRUCTIONSII1-1200 Issue B

4 25For example, to programme User Code 2 as 2626: Enter the Master User Code. Press: 8 2 2626. Two beeps confirm that the new code has been acce

5SECTION 2: INSTALLINGTHE ACCORDFixing the EnclosureThe two parts (lid and base) of the Accord control panel enclosure are connected by: Five pilla

6Figure 2.2 Enclosure Base Layout.Spares PackThe Accord control panel comes with a spares pack. This contains ten zone links, fivemounting pillars and

7Assembling the Control Panel Into theEnclosure1. Insert the four plastic PCB support pillars into the four holes in the enclosurebase, see Figure 2.2

8Connections to the AccordMounting and Wiring the LED Remote KeypadTo mount and wire the Accord LED keypad:1. Press down the two base clips recessedon

9Connecting the External SoundersConnections for Self Actuating Bells and Bell/Siren combinations should be made asoutlined in Table 2.2 Connections f

10Figure 2.4 Connections to the Accord.Testing the InstallationPower-up and Initial Test ProcedureWhen the Accord control panel has been installed in

111. Apply input power to the mains transformer.2. Check that the Auxiliary Voltage at terminals AUX + and AUX  on the mainterminal strip measures be

12SECTION 3: PROGRAMMINGTHE ACCORDGetting In and Out of Programming ModeAll zone and system programming must be carried out from Programming Mode. To

13Programming Groups 1, 2 and 3Programming Groups one to three are used to programme the eight zones for each ofthe three setting modes: Full, Part an

ii

14Zone Programming  Group 3 Night Set The first digit entered is 3 for Night Set. The second digit is the zone number (1  8). The third digit is

iiiTable of ContentsSECTION 1: WIRING AND SAFETY INFORMATION ... 1Wiring and Safety Information ...

ivSystem Programming  Group 4 System Options ... 14Group 4  Option 1 Exit Time ...

vDisabling the Chime Function On All Zones ... 25Viewing the Log [0] ...

vi 29APPENDIX A:SPECIFICATIONSPanel SpecificationPhysical Width: 195 mmHeight: 285 mmDepth: 90 mmElectrical Mains Input: 230 V a.c. (+10% -8%) 50 Hz

1SECTION 1: WIRING ANDSAFETY INFORMATIONWiring and Safety InformationIt is essential that this product is installed correctly, in particular with resp

2Knockouts must only be removed if cables are to enter the cabinet at that point. Thehole must be covered by the trunking or conduit or by means of a

3FusesThe mains fuse within the cabinet is rated at 100 mA.The mains supply must be disconnected before opening the cabinet and changingthe fuse. Repl