ADEMCO Security System VISTA-15CN Einstellungsanleitung PDF herunterladen (Seite 72)

VISTA-15/VISTA-15CN Installation and Setup Guide

15–10

✱

78 DAYLIGHT SAVING TIME START/END WEEKEND 1 | 5

0 = disabled 4 = fourth

1 = first 5 = last

2 = second

6 = next to last

third

7 = third to last

DYNAMIC

SIGNALING

(

✱

79)

✱

79 DYNAMIC SIGNALING DELAY (DSD) 1st entry 0

This field enables you to select the time the panel should wait for

acknowledgment from the first reporting destination before it attempts to

send a message to the second destination. Delays can be selected from 0 to

225 seconds, in 15-second increments.

This delay is per message

0–15 times a 15-second delay. e.g., 1 = 15 seconds, 2 = 30 seconds, etc.

Default is “0” (no delay). You must enter “0” for UL installations.

Note:

If ”0” is entered in this field, the control panel sends redundant reports

to both Primary phone number and LRR.

DYNAMIC SIGNALING PRIORITY (DSP) 2nd entry

This field enables you to select the initial reporting destination for messages,

Primary Phone Number or Long Range Radio.

0 = Primary Phone Number first; 1 = Long Range Radio (LRR) first.

Default is “0” (Primary Phone Number)

The following chart provides a concise explanation of how the Dynamic

Signaling feature functions.

If DSP (

✱

79)

is: And message is: Then:

Primary Phone

No.

(“0” entered)

Acknowledged before

delay expires

Not acknowledged before

delay expires

Message is removed from

queue and no message is

sent to LRR.

Message is sent to both the

Primary Phone Number and

LRR.

Long Range

Radio

(“1” entered)

Acknowledged before

delay expires

Not acknowledged

before delay expires

Message is removed from

queue and no message is

sent to Primary Phone

Number.

Message is sent to both the

Primary Phone Number and

LRR.

NOTE: You must enable field

✱

29, OUTPUT TO LONG RANGE

RADIO, if this feature is to function.

OUTPUT AND

SYSTEM SETUP

(

✱80 - ✱82;

✱84, ✱85;

✱87 - ✱93)

✱80 OUTPUT DEVICES

Interactive Menu mode applicable only if field

✱

25 is programmed for a 4204

or 4229, or if Powerline Carrier devices are being used.

Refer to Section 17: Output Device Programming for detailed procedure.

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 131 132

Kommentare zu diesen Handbüchern

Keine Kommentare

ADEMCO Security System VISTA-15CN Einstellungsanleitung Seite 72

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme ADEMCO Security System VISTA-15CN