ADEMCO Security System VISTA-15CN Einstellungsanleitung PDF herunterladen (Seite 42)

VISTA-15/VISTA-15CN Installation and Setup Guide

7–4

Wiring Connections

To wire the Powerline Carrier device to the control panel, perform the following steps:

1. Splice one end of a 3-conductor cable to the wire ends of the 4142TR Cable supplied with

the 4300 Transformer.

2. Connect the 4142TR Cable Plug to the 9-pin connector on the control (see Figure 22.

Summary of Connections diagram for location of the 9-pin connector).

3. Connect the other end of the 3-conductor cable to the 4300 Transformer, as indicated in

the table below and in the diagram that follows.

4300 TRANSFORMER WIRE CONNECTIONS

4300 Terminal To Terminal on Control

1 (AC) 1 (16.5V AC in)

2 (Ground) 25 Earth Ground terminal

3 (AC) 2 (16.5V AC in)

4300 Terminal 4142TR Cable Wire

4 (Sync) RED (Pin 5 of 9-pin connector)

5 (Data) VIOLET (Pin 1 of 9-pin connector)

6 (Com) WHITE (Pin 4 of 9-pin connector)

123456789

9-PIN CONNECTOR

ON CONTROL BOARD

BLACK

BLUE

BROWN

GREEN

RED

WHITE

YELLOW

GRAY

VIOLET

4142TR CABLE

125 2

Earth

Ground

Sync

Data

Com

4300 TRANSFORMER INTERFACE

TERMINALS

ON CONTROL

BOARD

Figure 15. 4300 Transformer Wiring Connections

Programming Relay Outputs

In the VISTA-15/VISTA-15CN, each device must be programmed as to how to act (ACTION),

when to activate (START), and when to de-activate (STOP). Refer to the programming

procedures for

✱

80 and

✱

81 interactive modes that are provided in Section 13: Mechanics

of Programming, Section 17: Output Device Programming, and Section 18: Zone Lists

for specific programming details.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 131 132

Kommentare zu diesen Handbüchern

Keine Kommentare

ADEMCO Security System VISTA-15CN Einstellungsanleitung Seite 42

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme ADEMCO Security System VISTA-15CN