ADEMCO VISTA-128B Einstellungsanleitung PDF herunterladen (Seite 84)

VISTA-128B Installation Instructions

13-2

There are two subscriber ID’s programmed into the LRR: primary and secondary. These

correspond to the two subscriber ID’s programmed into the control for each partition. If a

subscriber ID for a partition is not programmed (disabling reports to that central station

phone number for that partition), the events enabled for the corresponding subscriber ID in

the LRR will not be transmitted.

If the event is to be reported to both phone numbers, dual reporting, then reporting through

the LRR, will be done in an alternating sequence. The first event in the queue will be

transmitted to the primary radio central station. Then this event will be transmitted to the

secondary radio central station. If the event was reported successfully via the control’s

dialer, it will be deleted from the radio’s transmission queue. The control will then proceed to

the next event in the queue.

If split reporting is selected for the VISTA-128B, then the LRR will follow that option. The

radio will send the appropriate reports to the primary and secondary central stations.

Wiring the Long Range Radio

Connect the data in/out terminals and voltage input terminals of the radio to the control’s

keypad connection points, terminals 6, 7, 8, and 9, as shown below.

RED

BLACK

GREEN

YELLOW

CONTROL

TERMINALS

7820

Figure 13-1. Wiring Long Range Radio to Keypad Terminals

Programming the Control for the Long Range Radio

The control’s subscriber ID can be passed to the LRR and incorporated into the transmitted

data; or the LRR can transmit the subscriber ID programmed in its own EEPROM, (see the

programming of the Long Range Radio in

Device Programming

in the

#93 Menu Mode

Programming

section).

An option exists to send the reports only via the LRR, bypassing the control’s dialer

completely (field ∗56).

There is an option to stop transmissions via the LRR if communication via the control’s dialer

to the central station was successful (field ∗57).

The LRR reporting options are defined by selecting categories of events for each subscriber

ID. Field ∗58 is for selecting the events for the primary subscriber’s ID; field ∗59 is for

selecting the events for the secondary subscriber’s ID. The reporting categories are: Alarms,

Troubles, Bypasses, Openings/Closings, System Events, and Tests.

The control can be programmed to transmit these reports by partition.

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 251 252

Kommentare zu diesen Handbüchern

Keine Kommentare

ADEMCO VISTA-128B Einstellungsanleitung Seite 84

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme ADEMCO VISTA-128B