ADEMCO VISTA-128B Einstellungsanleitung PDF herunterladen (Seite 221)

Section 29 - Keypad Functions

29-3

Notes:

• When using the Global Arm feature, if there are faults in any of the selected partitions,

the system will enter a Summary Mode in which the faulted zones of all of the selected

partitions will be displayed. These faults must be corrected or bypassed (code + BYPASS

+ [#] will attempt to bypass the faults in all of the selected partitions). This Summary

Mode will end in approximately 120 seconds if no keys are pressed.

•

If, when disarming the system using a Global Disarm, any of the selected partitions has a

condition which would cause the keypad to beep (such as alarm memory or a trouble

condition), the system enter a Summary Mode in which the alarm memory or trouble

conditions of all of the selected partitions will be displayed. This mode will continue until

either approximately 120 seconds elapses or a second disarm occurs which clears the

beeping.

Access Control

The system has the capability to utilize access control by one of 3 methods.

1. One relay may be used for access control in each partition. The relay is programmed in

data field 1*76. To activate this relay, the user enters his User Code + [0]. The relay will

pulse for 2 seconds.

2. For a more powerful method of access control, program input devices (keypads, RF

buttons, hardwired) and output devices (relays) as access points (see the Access Control

section). Up to 32 access point devices (relays) among 8 partitions can be controlled. For

example, if a keypad is programmed as an access input device, then entering [User

Code] + [#73] or [User Code] + [#74] will activate the appropriate access point relays

(see also Zone Programming and Relay Programming in the #93 Menu Mode section).

If a Vista Gateway Module is installed along with the ADEMCO PassPoint Access

Control System, then these same inputs will automatically control the appropriate access

points in the PassPoint ACS. Entering

[User Code]

[#75]

will control the state

(protect, bypass, lock) of a door.

Delaying Closing Time

If open/close schedules are used, end users can manually delay closing time by extending the

closing window by 1 or 2 hours. This is useful if a user must stay on the premises later than

usual. The user must have an authority level of Manager or higher.

To extend the closing window, enter [User code] + [#] +82.

Closing Delay ?

Hit 0-2 Hours

Enter the number hours, 1 or 2, by which the end of the closing

window should be extended. Note that the delay is from the

scheduled closing time, not from the current time.

Press [∗

]

to accept entry and exit this mode. Press [#] to exit

this mode without changes.

The system will send an Access Schedule Change report to the

central station when the closing window is extended (if

programmed).

An extension of the closing window cannot be reduced once it is set. However, a 1-hour delay can

be increased to 2 hours. This is to prevent the user from deleting the delay after the normal window

expires, thereby missing the end of the window.

1 2 ... 216 217 218 219 220 221 222 223 224 225 226 ... 251 252

Kommentare zu diesen Handbüchern

Keine Kommentare

ADEMCO VISTA-128B Einstellungsanleitung Seite 221

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme ADEMCO VISTA-128B