ADEMCO VISTA-128B Einstellungsanleitung PDF herunterladen (Seite 157)

Section 23 - #93 Menu Mode Programming

23-19

Custom Message Display (Installer's Message)

Normally, when the system is in the disarmed state, the following display is present on the

keypad.

****DISARMED****

READY TO ARM

Part or all of the above message can be modified to create a custom installer message for each

partition. For example, “****DISARMED****” on the first line or “READY TO ARM” on the

second line could be replaced by the installation company name or phone number for service.

Note that there are only 16 character spaces on each of the two lines. To create a custom

display message, proceed as follows:

Select Default Screen Mode.

The keypad will ask for the partition number for this message.

Enter the partition number. Press [∗] to accept entry.

The following will appear:

****DISARMED****

READY TO ARM

A cursor will be present at the extreme left of the first line (over the first "star"). Press 6

to move the cursor to the right and 4 to move the cursor to the left. Press 7 to insert

spaces or erase existing characters.

Create the message.

For example, to replace “READY TO ARM” with the message

“SERVICE 424-0177,” proceed as follows:

Press 6 to move the cursor to the right, and continue until the cursor is positioned over

the first location on the second line.

Press 3 to advance through the alphabet to the first desired character (in this case, "S").

Press 1 to go backward, when necessary. When the desired character is reached, press 6.

The cursor will then move to the next position, ready for entry of the next character (in

this example, "E"). When the cursor reaches a position over an existing character, press 3

or 1 to advance or back up from that character in the alphabet.

Proceed in this manner until all characters in the message have been entered.

Save the message.

Store the new display message in memory by pressing 8.

The system will ask for a new partition number.

Enter 0 to quit or 1-8 for a new partition number.

1 2 ... 152 153 154 155 156 157 158 159 160 161 162 ... 251 252

Keine Kommentare

ADEMCO VISTA-128B Einstellungsanleitung Seite 157