ADEMCO VISTA-120 Einstellungsanleitung PDF herunterladen (Seite 52)

Vista 120 Training Guide 52

7. Servicing Tips

Training Module

POWER CONSIDERATIONS:

The Vista 120 has a:

12V 750mA Auxiliary power output

12V 2.8A Alarm sounder output

128mA Polling loop output

If Power is of Concern:

Please refer to the current drain Work sheets on Page 60 of the Installation Instructions

If an additional power supply is required, ensure there is a ‘common ground’ connection

between the power supply and the control

SUPERVISORY ZONES - (see Page 68 Installation Manual)

Zones 601 – 696

Relay Zones – To supervise relay, use the Zone programming menu to enter a response type

5 or 19 for that Relay’s zone number

Zones 800 - 830

ECP device Supervisory Zones (includes Consoles, wireless receivers, VIP Module, relay

modules) programmed through Device Addresses.

Zone 988 – 2

Receiver not receiving signals

Zone 990 – 1

Receiver not receiving signals

Zone 997 – Polling Loop overload

Zone 995 – 1 + * panic (A Key)

Zone 996 – 3 + # panic (C Key)

Zone 999 – * + # panic (B Key)

CHECK CONDITIONS:

• Fire zones: Indicates an Open circuit

• Wireless zones: May be caused by some change in the environment preventing the

receiver from receiving signals from that particular sensor OR that the transmitter’s tamper

has been activated

LOW BATTERIES:

• Low battery & zone number indicates a low battery in the wireless sensor displayed

• Low battery & “00” zone number indicates a low battery in a 5827 or 5827BD wireless

console.

• Low battery & no zone number indicates the system’s main battery is weak & the System

may be difficult to disarm, if in alarm

1 2 ... 47 48 49 50 51 52 53

Keine Kommentare

ADEMCO VISTA-120 Einstellungsanleitung Seite 52