ADEMCO VISTA-120 Einstellungsanleitung PDF herunterladen (Seite 43)

Vista 120 Training Guide 43

6.3 5804 Four Button Remote

Training Module

• Each Button is a separate zone. (Max 4 Zones per Remote)

• It is advisable to mark the Key with the first zone number, so they can be identified when

required

• To avoid “check” conditions, Loop 4 must be programmed into the system

• Install & program 5882 Wireless receiver(s) as per 5882 Instructions

• Enter program mode. (Installer code + 8 + 000)

• Go to #93 and select “Enter Zone programming”

• Select an unused zone from 010-128

• Program zone type as required (eg. 20= arm stay, 21= arm away, 22= disarm)

• Select partition and report code for remote key

• Select input type 5 (Button RF)

• Learn loop button being used on that particular zone by pressing button

• Console will display first transmission received

• Press the same button again

• Console will display “Confirmed”

• Repeat procedure for each of the 4 buttons on the remote

• Leave program mode

• Proceed to program a user code

- mastercode + 8 + unused user (002-128) + new user code

• Select authorisation level required

• Open and close reporting (yes/no)

• RF button (1 = yes)

• Allocate the first of the 4 zone numbers used for the remote when prompted

• Loop 4 must be programmed into the system to avoid “check” conditions

* See user programming instructions on page 34 for details

AVAILABLE ZONE TYPES:

Type 06 = 24 Hour Silent Alarm

Type 07 = 24 Hour Aud. Alarm

Type 08 = 24 Hour Aux. Alarm

Type 09 = Supervised Fire

Type 20 = Arm - Stay

Type 21 = Arm – Away

Type 22 = Disarming

Type 23 = No alarm response

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 52 53

Keine Kommentare

ADEMCO VISTA-120 Einstellungsanleitung Seite 43