ADEMCO VISTA-120 Einstellungsanleitung PDF herunterladen (Seite 46)

Vista 120 Training Guide 46

6.5 5827 Wireless Keypad

Training Module

• Install & program 5882 Wireless receiver(s) as per 5882 Instructions

• Ensure that a House ID has been assigned to the Wireless receiver(s). Test for other

systems with ID Sniffer Mode (Mastercode + # + 2). Recommended test time 2 hours.

Mastercode + 1 will end sniffer test.

• Enter Program Mode

• Enter * 94 to move to the next programming page.

• Go to location 1*32 to set the receiver type 2 = 5881.

• Go to location 1*48 to assign the 5827 to the partition as required.

• *99 back to previous programming page.

• Go to location #93 select “Device” programming. Enter the address number as set on the

receiver. Enable that device as a type 3 (RF Expander). At the next prompt assign the

house code as decided after sniffer mode. (See example 1)

• Exit program mode.

• Adjust the dip switches on the 5827 to suit the house ID with the batteries disconnected.

• User codes are unable to be programmed via the 5827 wireless keypad.

EXAMPLE 1

OFF

16 8 4 2 1

(Binary Programming)

8 on = 8

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 52 53

Keine Kommentare

ADEMCO VISTA-120 Einstellungsanleitung Seite 46