ADEMCO VISTA-120 Einstellungsanleitung PDF herunterladen (Seite 41)

Vista 120 Training Guide 41

6.2 5882 Wireless Expansion

Training Module

There are three (3) models of 5882:

Ø 5882L will permit up eight (8) additional RF zones.

Ø 5882M will permit up to sixteen (16) additional RF zones.

Ø 5882H will permit up to one hundred & twenty eight (128) additional RF zones.

Note: Two identical receivers can be used to provide either a greater area of coverage, or

to provide redundant protection.

Zone 64 cannot be programmed for a Wireless zone.

If using two (2) receivers

Each unit must be set to a different device address between 01-07.

Using two (2) receivers DOES NOT increase the number of transmitters the system can

support.

Both receivers must be of the same model.

Receivers should be mounted at least 3 Metres from the Control Panel.

TO INSTALL WIRELESS RECEIVERS

Connect 5882 via the flying lead supplied to terminals 6 (RED), 7 (BLACK), 8 (GREEN) and 9

(YELLOW) of the Vista 120a.

Set 5882’s DIP switch to an unused device address between 01-07.

Use 6139 console to enter programming mode: installer code + 8 0 0 0

Enter *94 to move to 2

Level of Programming

Program 1*32 “Receiver Type”, enter 2 (for 5881/5882).

Enter *99 to return to 1

level of programming

Press # 9 3 to enter Menu Mode.

Press 0 (NO) until “Device Prog?” is displayed, then press 1 (YES).

• Enter the two digit Address Number (01 – 07), as set on the 5882’s Dip Switches

• Press * to move to Device Type

• Enter a Device Type “3” for RF Expander

• Press * to move to RF Expander House ID

If not using a ny RF keypads (5804BD, 5827BD or 5827, press * to continue.

If one, or more than one RF keypads are to be used, enter the two (2) digit House ID (00-31)

as determined by sniffer mode.

If two 5882’s are to be used, follow the same procedure until all outp ut devices have been

programmed, enter 0 0 * to exit “Device Prog?”.

Console will display “Quit Menu Mode?”, enter 1 (Yes) or 0 (No) if more devices need to be

programmed.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 52 53

Keine Kommentare

ADEMCO VISTA-120 Einstellungsanleitung Seite 41