ADEMCO VISTA-120 Einstellungsanleitung PDF herunterladen (Seite 40)

Vista 120 Training Guide 40

4208 Hard Wired Expansion Cont.

• Press * to move to Report Code

• Press * (3 times) to move to Input Type

• Enter the Input Type as “06” Serial Number Polling Loop Device

• Press * to move to Smart Contact

• Leave as “0” (This is used for devices that monitor maintenance signals)

• Press * to move to V-Plex Relay

• Leave as “0” (This is used for Polling Loop Relays)

• Press * to move to Loop #

• Enter the Zone’s Loop Number (1 – 8)

• Press * to move to Learn S/N

• Enter Yes “1”

• Enter the 7 digit Serial Number applicable to that Zone or activate the Zone Concerned, or short Zone input

• Press * to move to Zone Summary

• Press * to move to enter next Zone Number

• Repeat above procedure until all required zones are configured, then Enter “000” & “*” at “Zone No.” prompt

to move to “Quit Menu Mode”.

• Enter 1 for Yes or 0 for no if more programming is required.

• The polling loop itself is a zone (997), and it has a default response type of 05, Trouble by Day/Alarm by

Night. No change is required.

• When programming is complete, enter * 9 9 to exit program mode.

For full system information and programming details refer to Vista-120a Installation & Setup Guide.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 52 53

Keine Kommentare

ADEMCO VISTA-120 Einstellungsanleitung Seite 40