ADEMCO VISTA-120 Einstellungsanleitung PDF herunterladen (Seite 24)

Vista 120 Training Guide

VISTA 120 PROGRAMMING FORM

Some fields are programmed for each partition (shown as shaded fields). See the PARTITION-SPECIFIC section for programming these

fields. Standard default (*97) values are shown in brackets [ ], otherwise default = 0.

1*28 RF TX LOW BATTERY SOUND [0] 1=immediate; 0=when disarmed

1*29 RF TX LOW BATTERY REPORT ENABLE [0] 1=enable; 0=disable

1*30 RF RCVR CHECK-IN INTERVAL | [06] 02-15 times 2 hours; 00 disables supervision

1*31 RF TRANSMITTER | [12]

CHECK-IN INTERVAL 02-15 times 2 hours; 00 disables transmitter supervision

1*32 RF RECEIVER TYPE [0] 1=4281; 2=5881/5882

1*33 MULTIFREQUENCY with [0]

PULSE DIAL BACKUP 1=enable; 0=disable

1*34 COMM. SPLIT REPORT SELECTION [0]

0=no; 1=alarms and alarm restores primary, others secondary; 2=open/close, test secondary, others primary; See T51 for

comments if using with dual reporting.

1*35 LOW BATTERY TEST INTERVAL [0]

1 = 1.5 second test every 50 seconds

0 = 13 second test every 4 minutes

1*36 CPU FAIL TRIGGER OUTPUT [0]

1 = yes, Output trigger 2 on J7 to be CPU fail output, overriding any

other selection for Output 2 (CENELEC requirement)

0 = no, normal use for Output 2

1*37 TLM INPUT ON ZONE 9 [0]

1 = yes, telephone line fault monitor output to be fed into zone 9

0 = no, normal use for zone 9

1*38 USER RESET OF TAMPER ALARMS [0] ( 1 = Recommended )

INSTEAD OF INSTALLER ONLY RESET 1 = yes 0 = no

1*39 USER BYPASS OF TAMPER [0] ( 1 = Recommended )

FAULTS INSTEAD OF 1 = yes

INSTALLER ONLY BYPASS 0 = no

1*40 MAX. NUMBER OF ZONES THAT | [00]

CAN BYPASSED PER PARTITION 01-15, 00 = no restriction

(partition-specific)

1*41 BYPASS/UNBYPASS ZONES [0]

WHEN ARMED 1=Yes; 0=No.

1*42 CALL WAITING DEFEAT [0]

1=Yes; 0=No.

1*43 PERM. KEYPAD BACKLIGHT Partition-Specific

1*44 WIRELESS KEYPAD [1] (Locks out keypad after 20 key sequential key presses)

TAMPER DETECT ENABLE 1=enable; 0=disable.

1*45 EXIT DELAY SOUNDING Partition-Specific

1*46 AUXILIARY OUTPUT MODE [0]

0 = ground start output; 1 = open/close trigger; 2 = keypad-like

sounding 3 = AAV module is being used

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 52 53

Kommentare zu diesen Handbüchern

Keine Kommentare

ADEMCO VISTA-120 Einstellungsanleitung Seite 24

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme ADEMCO VISTA-120