ADEMCO Vista-128B PLUS Einstellungsanleitung PDF herunterladen (Seite 28)

– 28 –

Press [0] to display the next mode available. The alpha menu selections are:

ZONE DESCRIP?

For entering zone descriptors.

DEFAULT SCREEN? For creating custom message; displayed when system is ready.

CUSTOM WORD?

For creating custom words for use in descriptors.

PART DESCRIP?

For creating 4-character partition names.

EXIT EDIT MODE? Press [1] to exit back to #93 Menu Mode.

4. Refer to the sections that follow for procedures for adding alpha descriptors.

Zone Descriptors

1. Select ZONE DESCRIPTOR mode.

The keypad keys perform the following functions:

[3] Scrolls both alphabet and actual words in ascending alphabetical order.

[1] Scrolls both alphabet and actual words in descending alphabetical order.

[2] Adds or removes an "s" or " 's " to a vocabulary word.

[6] Switches between alphabet and actual word list; used to accept entries.

[8] Saves the zone description in the system's memory.

[#] [#] plus zone number displays the description for that zone.

2. Enter the zone number to which you want to assign a descriptor.

For example, key [✱] 001 to begin entering the description for Zone 1, (key [✱] 002 for Zone 2, [✱] 003 for Zone 3, etc.).

The following is displayed: ✱ ZN 001 A.

Note that the first letter of the alphabet appears after the zone number, and that the zone number is automatically

included with the description.

3. Enter the descriptor for that zone.

Use one of two methods as follows:

(Assume, for example, that the desired description for Zone 1 is BACK DOOR.)

a) Press [#] followed by the 3-digit number of the first word from the fixed dictionary shown later in this section (e.g.,

[0][1][3] for BACK).

Press [6] in order to accept the word and proceed, or press [8] to store the complete descriptor and exit;

b) Select the first letter of the desired description (note that "A" is already displayed). Use the [3] key to advance

through the alphabet and the [1] key to go backward.

Press [3] key repeatedly until "B" appears (press [1] to go backwards if you happen to pass it), then press [6] to

display the first available word beginning with “B”.

Press [3] repeatedly to advance through the available words until the word “BACK” is displayed.

To add an "s" or " 's," if you need to, press 2. The first depression adds an "s," the second depression adds

an " 's, " the third depression displays no character (to erase the character), the fourth depression adds an

"s," etc.

4. Accept the word.

To accept the word, press [6], which switches back to the alphabet list for the next word, or press [8] to store the

complete descriptor and then exit.

5. Select the next word.

For selection of the next word (DOOR), repeat step 3a (word #057) or 3b, but selecting the word "DOOR.”

To accept the word, press [6], which again switches back to alphabet list.

6. Store the descriptor.

When all desired words have been entered, press [8] to store the description in memory.

To review the zone descriptors, key [#] plus zone number (e.g., #001).

To edit zone descriptors, key [✱] plus zone number (e.g., ✱001)

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 71 72

Kommentare zu diesen Handbüchern

Keine Kommentare

ADEMCO Vista-128B PLUS Einstellungsanleitung Seite 28

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme ADEMCO Vista-128B PLUS