ADEMCO Vista-128B PLUS Einstellungsanleitung PDF herunterladen (Seite 14)

– 14 –

Programming With #93 Menu Mode

NOTE: The following field should be preset before beginning: 2*00 Number of Partitions. In addition, receivers should

be programmed via Device programming.

After programming all system related programming fields in the usual way, press #93 while still in programming mode to

display the first choice of the menu driven programming functions. Press 0 (NO) or 1 (YES) in response to the displayed menu

selection. Pressing 0 will display the next choice in sequence.

NOTE: All references in this manual for number of zones, number of user codes, number of access cards, and the

event log capacity, use the VISTA-250BP’s features. See page 2 of this manual for the table listing the differences

between the VISTA-128BP and the VISTA-250BP control panels.

For UL installations, verify that the audio alarm verification feature is disabled.

#93 MENU MODE KEY COMMANDS

The following is a list of commands used while in the menu mode.

#93 Enters Menu mode

[✱] Serves as ENTER key. Press to have keypad accept entry.

[#] Backs up to previous screen.

0 Press to answer NO

1 Press to answer YES

001-009 All data entries are either 2-digit or 3-digit entries.

000 Exits menu mode, back into field programming mode, when entered at the first question for each category.

Menu selections are as follows:

PROMPT

EXPLANATION

ZONE PROG?

1 = YES 0 = NO 0

For programming the following:

• Zone Number

• Zone Response Type

• Partition Number for Zone

• Dialer report code for zone

• Input Device Type for zone (whether RF, polling loop, etc.)

• Enrolling serial numbers of 5800 Series transmitters & serial polling loop devices into the system.

• Zone Attributes (e.g., Arm w/Fault, Silent, etc.)

EXPERT MODE?

1 = YES 0 = NO 0

Same as Zone Programming except:

• Done with a minimum number of keystrokes.

• Can program wireless keys using pre-defined templates.

NOTE: Some of the zone attributes cannot be programmed in the Expert Mode, only in Zone Programming.

REPORT CODE PROG?

1 = YES 0 = NO 0

For programming the following:

• Alarm report codes for zones

• Restore & supervisory codes

• All other system report codes

ALPHA PROG?

1 = YES 0 = NO 0

For entering alpha descriptors for the following:

• Zone Descriptors

• Installer's Message

• Custom Words

• Partition Descriptors

• Relay Descriptors

DEVICE PROG?

1 = YES 0 = NO 0

For defining the following device characteristics for addressable devices, including keypads, RF receivers

(5881), output relay modules (4204/4204CF), FSA modules, 4285/4286 VIP Module, ECP Long Range Radio

(7820), Panel Link module, and VISTA gateway module:

• Device Address

• Device Type

• Keypad Options (incl. partition assignment)

• RF House ID

• LRR Options (incl. programming radio)

• Panel Linking Options

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 71 72

Kommentare zu diesen Handbüchern

Keine Kommentare

ADEMCO Vista-128B PLUS Einstellungsanleitung Seite 14

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme ADEMCO Vista-128B PLUS