ADEMCO Vista-50 Bedienungsanleitung PDF herunterladen (Seite 178)

– 166 –

Section 26: TESTING THE SYSTEM

This section provides the following information:

• Using Test Mode

• Turning the system over to the user

• Trouble conditions

Using Test Mode

General Information

After the installation is completed, thoroughly test the Security System on a

partition by partition basis as follows:

1. With the System in the disarmed state, check that all zones are intact. If

DISARMED - Press T to show faults is displayed, press the * key to display

the descriptors of the faulted zone(s). Restore faulted zone(s) if necessary, so

that ****DISARMED*** READY TO ARM is displayed.

2. Enter the security code and press the TEST key. The external sounder (if

used) should sound for 3 seconds and then turn off (the system is operating

on the back-up battery only at this time).

NOTE 1. If the sounder does not sound, this may be an indication that the

backup battery is discharged or missing.

NOTE 2. As a reminder that the system is in the Test mode, the keypad will

sound a single beep at 15-second intervals.

NOTE 3. In the Test mode, no alarm reports will be sent to the central station

for the partition being tested. Also, the external sounder (if used) will not be

activated.

NOTE 4: Test mode is active only for the partition at which Test mode is

entered. Other partitions are still operative and will cause the external

sounder and communicator to activate if an alarm condition occurs.

Doors and Windows

• Open and close each protected door and window in turn. Each action should

produce three beeps from the keypad. The descriptor for each protection zone

will appear on the keypad display.

Motion Detectors

• Walk in front of any interior motion detectors. Listen for three beeps when the

detector senses movement. While it is activated, its descriptor will remain

displayed on the keypad. Note that wireless PIRs will have a 3 minute lockout

between transmissions to conserve battery life (remove cover for walk test to

override the 3-minute lock-out on 5700 series units, move jumper inside 5800

series units to "Test" position (put back to "Normal" position when test is

complete)).

Smoke Detectors

• Follow the test procedure provided by the manufacturer of each smoke

detector to ensure that all detectors are operational and are functioning

properly.

NOTE: A 2-wire smoke detector display will not clear until the Test mode is

exited.

Turning Off TEST mode

• Enter the security code and press the 1 (OFF) key.

1 2 ... 173 174 175 176 177 178 179 180 181 182 183 ... 195 196

Kommentare zu diesen Handbüchern

Keine Kommentare

ADEMCO Vista-50 Bedienungsanleitung Seite 178

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme ADEMCO Vista-50