ADEMCO Vista 4130XT Bedienerhandbuch PDF herunterladen (Seite 6)

Commanding:

There are two types ot commands that can be issued to the system:

1. Control Commands —

- To Arm the System in the Away Mode* (’)

- To Disarm the System* (t)

- To Bypass a Zone

- To Force the System to Accept a New Program Download

- To Shut DowrI Communication (dialer) Functions (non-payment of

monitormg fees m an owner’s system)

- To Shut Down all Security System Functions (non-payment for a

leased system)

- To Inhibit Local Keypad Programming (prevents takeover of your

accounts)

2. Status Commands —

- To Cause the System to Upload a Copy of its Resident Program to

the central station

To Read System Status:

Arming Status

Ready Status and Current Faults

Presence of Alarms (pastor present)

Presence of Troubles (past or present)

AC Power Status

Bypass Status and Current Bypasses

*NOTES

1.If the system is programmed for open/close reporting by

user, User #7 will be reported.

2. After the4130XT and the 699 or PC have established valid

communication, each 4157 console displays an ‘OC’ sig-

nifying that It IS busy (occupied). Also, the 4130XT is not

responding to faults in its zones. The 4130XT will resume

the normal security tunctlons (mcludmg responding to faults

that look place during the downloading) after it is com-

manded to hang up See the 4130PC or 695-30XT instruc-

tions for details.

The detailed operation of the functions described below IS covered m the

Installation Instructions for the No. 695-30XT Program Cartridge and for

the 4130PC Download Software Diskette.

To Read List of Faulted Sensors

To Read List of Bypassed Sensors

- To Read 10 Day Alarm History Log

- To Read 10 Day Trouble History Log

- To Read List of Sensors Currently m Alarm

- To Read List of Sensors Currently in Trouble

Remote Communication Specifications:

Program Download Time — 1 minute for a complete program

. Typical Total Time Including Call Up/Call-Back — 3-4 minutes

Remote Command/Programming Advisory Notes:

● Alarm and Trouble Reporiing are disabled during the time that the SYS-

tem and the central station are linked to each other for the described

functions, following a valid exchange of codes.

● Keypad entries are ignored during the same time interval cited above.

. Should an alarm transpire during the remote program/control interval,

the system would not respond to the alarm condition untd the remote

mode was ended. The local zones and the Nos. 4190WH, 4192,

4194WH, 4196, and 4208 all store their fault conditions until they are

read by the Control, As such, alarm conditions from the local and

expansion zones would not be missed, only delayed.

. A copy of the program downloaded may be produced from either the

No, 699 Intelligent Programmer or the IBM PC compatible computer,

using those products’ internal report generators, when an optional prin-

ter is connected.

1 2 3 4 5 6 7 8 9 10 11 ... 83 84

Kommentare zu diesen Handbüchern

Keine Kommentare

ADEMCO Vista 4130XT Bedienerhandbuch Seite 6

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme ADEMCO Vista 4130XT