ADEMCO Vista 4130XT Bedienerhandbuch PDF herunterladen (Seite 28)

Installer options are stored in non-removable, electrically erasable, non-

volatile EEPROM memory. These options must be programmed for the

particular installation to establish its specific alarm and reporting

feat ures.

The security control may be programmed from its own keypad (the most

convenient method) or from an optional 4137 or 4157 remote console, or

can be programmed locally from the 699 Programmer. Information

regarding the Programmer is included with the No. 695-30XT Program-

ming Cartridge.

The system is factory-programmed to a set of preset values, which can

be altered by the Installer to suit the specific needs of a parhcular instal-

lation or installation company. The preset values are detatled (n the Fac-

tory Programming Table.

Nottz Programming mformatlon E stored In non-volatlle EEPROM

memory in this Control (removal of power WIII

not result in the loss

of the information). Consequently, it is possible to program the

Control at any time – even at the installer’s premises prior to the

actual installation. Simply apply DC power temporarily to the Con-

trol and then program the unit as desired.

When programming from the Control, note the following”

1, Enter the Programming mode by simultaneously depressing the * and

# keys within 30 seconds after power is applied to the Control, or sub-

sequently by keying the code 4 +

1 +3 + O followed by depression of

CODE + O + O keys. Once an Installer code is programmed, use it

instead of 4130 (as 4130 is no longer present) to gain access to the

programming mode.

When a data tleld has been completely programmed, the Control WIII

“beep” three times and then automatically proceed to, and display, the

next data field address to be programmed.

If the number of dlglts that yob enter In the data field IS less than the

maximum permitted (for example, phone number), then the Control wit

display the last data entered. To proceed, the next data field address

to be programmed must then be entered (for example, *OS).

If an address is lm~ro~erly entered, the Control will discday FC. If a

program entry IS rnprope~ly entered (for example, a larger number

than that which is permitted), the Control display WIII go blank. In

either case, simply re-enter the number.

The followlng ISa description of commands necessary for programming,

FUNCTION

PROCEDURE

ENTER PROGRAM- 1. POWER UP, then depress *and #simultane-

MING MODE:

ouslywithln 30 seconds of powering up.

2 Initially,

Key:4+l +3+ OPIUSCODE key+O+O.

3 After Installer Code

IS programmed, key”

Installer Code + CODE key + O + O.

Notes: User #l (Installer) must be enabled (in

Address 52) if Type 3 method of entry Isto

be used.

Type 3 method of re-entry to the pro-

gramming mode is inhibited if the pro-

gramming mode E,exited vla use of *98

Type 1 method of entry can always

be used unless console programming

has been locked out by the remote

downloader.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 83 84

Kommentare zu diesen Handbüchern

Keine Kommentare

ADEMCO Vista 4130XT Bedienerhandbuch Seite 28

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme ADEMCO Vista 4130XT