ADEMCO Vista-50 Einstellungsanleitung PDF herunterladen (Seite 18)

VISTA-50P/VISTA-50PUL Installation and Setup Guide

3-6

Telephone Line Connections

Connect the main dialer output to telephone company

lines using the RJ31X cables supplied.

The telephone line inputs have overvoltage

protection in accordance with UL1459, as

specified in UL985/UL1023.

The system is shipped defaulted for Contact ID

format. It is the only format capable of uniquely

reporting all 86 zones, as well as openings and

closings for all 75 users. This requires central

stations to be equipped with the 685 receiver

using software level 4.10 or higher. If you need

an update, contact your distributor.

To prevent the risk of shock, disconnect

phone lines at the telco jack before servicing.

If the communicator is connected to a PABX,

be sure it has a backup power suppl

that can

support the PABX for 24 hours (central

station) or 60 hours (remote station). Many

PABXs are

not

power-backed up, and this can

result in a communication failure if power is

lost

Reporting Formats

The system supports the following formats:

ADEMCO Low Speed 3+1; 4+1; 4+2; Sescoa/Radionics

3+1; 4+1; 4+2; ADEMCO 4+2 Express; ADEMCO High

Speed; ADEMCO Contact ID

TERMINALS

ON CONTROL

EARTH GROUND

INCOMING TELCO LINE

Handset

TIP

RING

RJ31X

JACK

PLUG

DIRECT

CONNECT

CORD

TIP

RING

GROUND

PREMISES

PHONES

{

BROWN (TIP)

GREY (RING)

GREEN (TIP)

RED (RING)

26 27 28 29 30

Incoming

Telco Line

Figure 3-8: Telephone Line Connections

Wiring Burglary, Panic, and Smoke Detector Devices to Zones 1-9

The maximum zone resistance is 100 ohms for

zones 1 and 8, and 300 ohms for all other

zones (excluding the 2K EOL resistor).

To wire burglary and panic devices to zones 1-9, connect

sensors/contacts to the hardwire zone terminals (10

through 23). See Figure 3-9. Connect N.C. and N.O.

devices as follows:

• Connect N.C. devices in series with the high (+)

side of the loop. The 2K EOL resistor must be

connected in series with the devices, following the

last device.

• Connect N.O. devices in parallel (across) the

loop. The 2K EOL resistor must be connected

across the loop wires at the last device.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 111 112

Kommentare zu diesen Handbüchern

Keine Kommentare

ADEMCO Vista-50 Einstellungsanleitung Seite 18

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme ADEMCO Vista-50