ADEMCO Security System Betriebsanweisung PDF herunterladen (Seite 44)

Ð 44 Ð

TESTING THE BURGLARY

SYSTEM

(TO BE CONDUCTED WEEKLY)

Using the

TEST Key

The TEST key puts your system into the Walk Test mode, which

allows each protection point to be checked for proper operation.

1. Disarm the system and close all protected windows, doors,

etc. READY should be displayed.

TEST

2. Enter your security code and press the 5 key.

3. The external sounder should sound for 3 seconds and then

turn off. If the sounder does not sound, it may be due to

dialer communication activity. Wait a few minutes and try

again. If the sounder still does not sound, CALL FOR

SERVICE IMMEDIATELY.

4. The keypad will sound a single beep every 15 seconds as a

reminder that the system is in Test mode.

Note that no alarm reports will be sent to the central

monitoring station while the system is in Test mode.

5. Open and close each protected door and window in turn and

listen for three beeps. The identification of each faulted

protection point should appear on the display.

6. Walk in front of any interior motion detectors (if used) and

listen for three beeps as movement is detected. The

identification of the detector should appear on the display

when it is activated. If a problem is experienced with any

protection point (no confirming sounds, no display), CALL

FOR SERVICE IMMEDIATELY.

7. Turn off Test mode by entering the security code and

pressing the OFF key.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 65 66

Keine Kommentare

ADEMCO Security System Betriebsanweisung Seite 44