
Ð 37 Ð
USING #70 RELAY MENU MODE
General
Information
Your system may be set up so that certain lights or other devices
can be turned on or off by using the #70 command from either a
keypad or a telephone keypad (if 4285 VIP module is used). Ask
your installer if this has been done in your system.
To activate relays from a keypad, enter 4-digit security code +
[#] +70. Follow the keypad prompts described below.
To activate relays using a telephone and 4285 VIP module,
first dial the 2-digit phone access code. When the system
acknowledges the access, enter 4-digit security code + [#] + 70.
The following prompts/voice responses will begin.
ENTER DEVICE NO.
00=QUIT 01
Voice: "ENTER DEVICE CODE NOW"
Enter the 2-digit number of the device to be
activated.
Note that if an invalid number is entered, the
system will simply ask you to reenter the
number.
NN DEVICE IS OFF
HIT 0=OFF , 1=ON
Voice: "
voice descriptor
DEVICE nn ON/OFF.
FOR
voice descriptor
ON ENTER 1, FOR
voice
descriptor
OFF ENTER 0"
Press 0 or 1 to turn the device off or on
respectively.
"nn" represents the 2-digit device number
and
voice descriptor
is the relay voice
descriptor programmed by the installer.
NN DEVICE IS OFF
HIT THE "✴" KEY
Voice: "
voice descriptor
DEVICE nn ON/OFF. TO
EXIT ENTER 00 NOW"
From a keypad, press ✴ to continue. The
ENTER DEVICE NO. prompt will appear.
From a telephone keypad, enter 00 to
exit, or enter the next relay number to be
programmed. The current on/off state of that
relay will be annunciated as described
above. Alternatively, if 6 seconds elapses
with no key depression, the 4285 VIP
module will annunciate the "ENTER DEVICE
CODE NOW" message.
Kommentare zu diesen Handbüchern