ADEMCO 4160-12 C-COM Bedienungsanleitung PDF herunterladen

~ADEMcOJ

No. 5330

ALPHA CONSOLE

INSTALLATION INSTRUCTIONS

—

MARGIN LINES INDICATE PRINCIPAL CHANGES IN THIS ISSUE_

GENERAL INFORMATION

The Ademco No. 533o Alpha Console is a microprocessor based remote

keypad console intended for use with any of the following Ademco secutity

alarm systems:

No. 4152/41 53 Vector Point Protection Systems

5600/5700 Alert Wireless Alarm System

No. 4180-1 2/41 60EC Protection System

No. 4160-12 Protection System

Msta Protection System

This document provides installation instructions and installer programming

procedures. For information regarding usage with specific secutity systems,

refer to the No. 533o User’s Manual for the system in use. The No. 533o Alpha

tinsole serves as the user’s intetiace to the secutity system and is functionally

identical to each of the listed systems’ remote keypad consoles, with several

major differences. first, the No. 533o features a 32 character English language

alphanumeric display (WO lines of 16 characters), as oppsed to the one or two-

digit numetic display/LED indicator mmbination found on the standard keypad

consoles. Thus, triggered zones or protection points are displayed

descriptively (e.g. BOBS BDRM WNDOW) rather than by numefical codes. In

addition. the No. 533o features a backlit kevDad which is used for entering

system commands, and can be used to creaid a custom installer or end-user

message that is displayed when the system is in the “ready to arm” state.

TABLE OF CONTENTS

TITLE

PAGE

GENE~L INFORMATION ... ....................... ......... ... .... .......... . .. 1

INSTALUTION ------------------------------------------------------------------------ 2

SURFACE MOUNTlNG--------------------------------------.---------------------------2

RECESS MOUNTING -------------------------------------------------------------------- 3

G~PHIC OVERUYS --------------------------------------------------------------- 4

POWERING THE CONSOLE ---------------------------------------------------------- 4

A~USTING WE VIEWING ANGLE .......................................... ........4

INSTALLERS D.A. PROGRAMMING MODE ------------------------------------- 5

KEYPAD FUNCTIONS ------------------------------------------------------------- 6

PR~RAMMING OVERVIEW -------------------------------------------------------- 7

EDIT MODE PROCEDURES ----------------------------------------------------------- 8

Device Seledion ............. . .................... ......................................... 8

Descti@ors ------------------------------------------------------------------------------- 8/g

Installer’s Message -------------------------------------------------------------------------- g

Installer’s Code ------------------------------------------------------------------------------g

DATA LOAD MODE PROCEDURES --------------------------------------------- 10

Programming From a No. 5330 Conmle ----------------------------------------- 11

FINAL CHECK ---------------------------------------------------------------------------- 12

SPECIFICATIONS ---------------------------------------------------------------------- 13

N3327V2

5/90

Previous Menu

1 2 3 4 5 6 ... 23 24

Inhaltsverzeichnis

Seite 1 - ~ADEMcOJ

~ADEMcOJNo. 5330ALPHA CONSOLEINSTALLATION INSTRUCTIONS—MARGIN LINES INDICATE PRINCIPAL CHANGES IN THIS ISSUE_GENERAL INFORMATIONThe Ademco No. 533o Al

Seite 2 - INSTALLATION

DATA LOAD MODE PROCEDURES(See Diagram 5)These procedures describe a means of programming (downloading) No. 533otinsoles from a master No. 533o Console

Seite 3

FINAL CHECK BEFORE TURNING THECONSOLE OVER TO THE USERBefore turning the Console over to the user, check all of thefollowing:Wing to the Console is co

Seite 4

SPECIFICATIONSPHYSICALLength: 7-3/4 (20.7cm)Wdth: 4-7/16” (11.3cm)Depth: 1-1/4” (3.2cm)For Metal Demr Flush Mountina. Order:5330 MK-BS: Brushed Brass5

Seite 5 - PROGRAMMING MODE

DIAGRAM 1: USER’S D.A. MODE MENUSNormalModeMessageDisplayedPress [“/1] + Code + [#/3)A kPress [#/3]4PgupPg up4l“staller’s D.A.User’s D.A. ModePg Dn/Pg

Seite 6

mPgupPg Uo Pg D.Pg upPg upc“StorelNext/Pg UP -Next/Prev/Pg UP -P,e”Il.Pg D“~Pg upIIPg D.Pg upscorePg upPg D“Are YouSure?See Diagram3BLS,dy(yn) _slore/

Seite 7

IEdit ModePg Dn/Next/Pg Up1Pg upPgupNextPg D.NextInstallers MsgNext—l“staliers CodeDevice selection—DescriptorsPg Dn/Next/Pg Up~ P9 DnlNext/Pg UP~revA

Seite 8 - (See Diagrams 3 and 4)

IIDescriptorsPg Dn/Next/Pg UP~:;’7‘;[:NextPg upPg D.IP9 UDPgup NextNextNextDescr,pt.r CODYDescriptor EditDescriptorRviewLPg Dn/Next/Pg UP ~revPg DnlNe

Seite 9

nData Load ModePg D“/N8xt/Pg U,11’Pgu,O“load 5330 ‘“x’IItP,,”Pg .“ Pg UD..,0, for Dnlaad(Irm 5330)IPQ UoIwhen s,.,. ,s0,.,,,6 at$0.,.. .0”s.1,D“load’”

Seite 10 - (See Diagram 5)

FEDERAL COMMUNICATIONS COMMISSION(FCC) STATEMENTThis equipment has been tested to FCC requirements and has been foundacceptable for use, The FCC requi

Seite 11 - CONSOLE OVER TO THE USER

THE LIMITATIONS OF THIS ALARM SYSTEMWhile this system is an advanced design secutity system, it does not offerguaranteed protection against burglary,

Seite 12 - SPECIFICATIONS

INSTALLATIONThe No. 5330 Alpha Console can be sutiace mounied or flush mounted. Referto the “Console Wifing” instructions in the Control/Communicator

Seite 13 - DnlNextlPg UP

r. m,,,.,,. ”THE LIMITATIONS OF THIS ALARM SYSTEM (cont.). Alarm warning devices such assirens, bells orhorns maynotaleti people orwake up sleepers wh

Seite 14

— NOTES —21

Seite 15

— NOTES —22

Seite 16

ADEMCOLIMITEO WARRANNAlarm Device Manufacturing Company, a ~vision of Rttway Corporation, and itsdivisions, subsidiaries and affliates ~Seller”), 165

Seite 17 - 5330)/PgUD

~ADEMCOJALARM DEVICE MANUFACTURING CO.A01.I,IONOFPITT..”CORPORATION165 Eileen Way, Syosset, New York 11791N3327V25/90Copyright01988 Pl~AY CORPORATION

Seite 18 - (FCC) STATEMENT

5. Plug theconnector into thereceptacle ontheback of the Console, makingsure that themnnector locks in place. Push theexcess wire back into thewall, p

Seite 19

GRAPHIc OVERLAYSme No. 5330 includes a package of graphic labels which identify the functionsof the keys for the system in use. The appropriate label

Seite 20

INSTALLER’S DIRECT ACCESSPROGRAMMING MODEThis mode is used by the installer when programming the Alpha Console to:. Selecithe $ystemlo which themnsole

Seite 21 - — NOTES —

KEYPAD FUNCTIONS DURING PROGRAMMING(Refer to the Installer’s Keypad Overlay N3702, which should be placed overthe keypad duting programming.)Numerical

Seite 22

PROGRAMMING OVERVIEW (See Diagram 2)When programming, use the following keys:PgDn: Selects the next lower menu, and accesses that menus sub-menusor te

Seite 23

EDIT MODE PROCEDURES(See Diagrams 3 and 4)Edfi ModePg Dn~exVPg UpTO display the Edit Mode sub-menus, press the [PgDn] key when “Edit Mode”is displayed

Seite 24 - ~ADEMCOJ

Descriptor ReviewPg Dn/Next/Pg UpPress [PgDn] to display descriptors which are currently in use. Press the[NextlPrev] key to display each descriptor i