PROGRAMMING OVERVIEW (See Diagram 2)
When programming, use the following keys:
PgDn: Selects the next lower menu, and accesses that menus sub-menus
or text windows.
PgUp: Exits the current menu or text window, and displays the next higher
level menu.
Next:
Displays the next menu or text window within the same programming
level.
Prev: Dis?lays the previously displayed menu or text window.
There are five pfima~ menus which are described in the following paragraphs.
Each of these primary menus contains sub-menus, which provide the actual
programming functions. TO display these menus, press the [PgDn] key when
the “installer’s D.A.” message is displayed. The Edit Mode Function will be
displayed. Press the [Next] or [Shift/Prev] key to display each of the other
functions.
Default Initialization: Used to clear all descriptors and return the Alpha
Console to its factoy default settings which are:
Device Selection = Vector
Installer’s tide = 533o
Installer’s Message = “Alpha Console”
Ademco
TO select the default initialization settings, press [Shift/Store] when “Default
Initialization” is displayed.
Revision Level: This display presents the software version number of the
software installed in the Alpha Console, which is helpful when contacting the
faclOV for service questions.
Edit Mode: Used to select the system to which the console is connected,
enter protection point or zone descriptors, and enter the installer’s message
and installer’s code. Refer to the “Edit Mode” procedures desctibed later for
additional information.
Data Load Mode: Used for programming remote consoles from a Master
Alpha Console. Refer to the “DATA LOAD MODE” procedures described later
for additional information.
Options: Used to select the keypad backlightir,g mode: either continuous or
light for 5 minutes upon key depression. TO select, press [PgDn] when
“Options” is displayed, then enter “Y for continuous backlighting or “N” for
temporary backlighting. When entered, press [Store], and press [PgUp] to
return to “Options” display. If “N” is selected, backlighting will only be on
following any key depression (for 5 minutes), duting entrylexit delay, duting
direct access mode, and whenever an alarm, trouble or descriptor is displayed.
The system defaults to continuous backlighting it neither “Y or “N” is seleded,
but will be tempora~ during AC power outages.
NOTE: The No. 553o will sequentially display all programmed protection
points when the command sequence [Secutity Code + “#” + “2”] is entered.
The message takes the form shown, where nn is the protection point ID
number and descdpdon isthe programmed description for that ID number.
P~rammti nn
descdptbn
7
(24 Seiten)
(173 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern