ADEMCO Alpha Vista Console Bedienungsanleitung PDF herunterladen (Seite 27)

GENERAL

INFORMATION

:;uRFj\cE MouN~,NG

~.,

MOUNTING THE CONSOLES

As indcated in the REMOTE CONSOLES section, at least one mnsole (i.e.: the

‘main” console) must ether be mounted on the ca~net door or mounted on an

electrical box located near (within 3 feet of) the cabinet. Run wires in conduit

between the electdcal box and the cabinet. Follow the SURFACE MOUNTING

instructions, below, when mounting this console. Additional supplemental

consoles can be surface or flush munted where desired and do not require the

use of an electr~al hx.

Remove the console’s back cover. The securing screw at the tront of the

wnsole must be removed to release the back cover as shown in the dagram

below.

For Dry Wall: usiW the back cover as a guide, make holes in the d~ wall for

the mnsole mounting screws and interface wiring. Pass the wiring through

the opening in the back wver, then munt ibis cover to the wall surface.

For Cabinet Door: use a 1/4 drill bit to enlarge the 3 holes on the door.

Mount the back cover to the door using 2 holes for console mounting screws

and 1 hole for interface wiring.

For Elecfri~l ~x: using the elecfriml box as a guide, make holes in the back

cover for the console mounting screws and interface wiring. Pass the

interface wiring through the opening in the back cover, then mount this rover

to the box.

Splice the interface wiring to the console wires. Insulated solderless wire

sphces (i.e.:311) maybe used for splicing,

Attach the main body of the @nsole to the mounted back cover. The mnsole

is properly attached when it snaps into place. Use the secuting screw

(previously removed) to secure the console to the back cover,

Back ,.,,, ofVISTA Console

that is mounted to the wa!l.

wiring through hole

\ and SPfice to Console wire*.

\ VISTA Cons.,,

securing ,Cre;

Figure 16. SURFACE MOUNTING CONSOLES

-27-

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 73 74

Keine Kommentare

ADEMCO Alpha Vista Console Bedienungsanleitung Seite 27