ADEMCO VISTA-5OUL Betriebsanweisung PDF herunterladen (Seite 42)

Testing Your 1.

System

TESTING THE SYSTEM

Open and close each protected door and window in turn and listen for three beeps.

The identification of each faulted protection point should appear on the display.

Walk in front of any interior motion detectors (if used) and listen for three beeps as

movement is detected. The identification of the detector should appear on the

display when it is activated.

Follow the manufacturer’s instructions to test all smoke detectors to ensure that all are

functioning properly. The identification of each detector (or the zone number of the

zone assigned to the detector) should appear on the display when each is

activated.

When all protection points have been checked, there should be no zone

identification numbers displayed. If a problem is experienced with any protection

point (no confirming sounds, no display), CALL FOR SERVICE IMMEDIATELY.

Turn off Test mode by entering the security code and pressing the

OFF key.

-42-

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 65 66

Keine Kommentare

ADEMCO VISTA-5OUL Betriebsanweisung Seite 42