ADEMCO VISTA-5OUL Betriebsanweisung PDF herunterladen (Seite 34)

USING #70 RELAY MENU MODE

General

Your system may be set up so that certain lights or other devices can be turned on or off by

Information

using the #70 command from either a

console or a telephone keypad (if voice module is used).

Ask your installer if this has been done in your system.

To activate relays from a console keypad, enter 4-digit security code + [#] +70. Follow

the console prompts described below.

To activate relays using a telephone and voice module, first dial the 2-digit phone

access code. When the system acknowledges the access, enter 4-digit security code + [#] +

70. The following promptshoice responses will begin.

Voice: “ENTER DEVICE CODE NOW

Enter the 2-digit number of the device to be activated.

Note that if an invalid number is entered, the system will simply ask

you to reenter the number.

Voice: “voice

descriptor DEVICE nn ON/OFF, FOR voice descriptor ON

ENTER 1, FOR voice descr@orOFF ENTER O

Press O or 1 to turn the device off or on respectively.

“nn” represents the

2-digit device number and voice descriptor is the

relay voice descriptor programmed by the installer.

Voice: “voice

descriptor DEVICE nn ON/OFF. TO EXIT ENTER 00 NOW”

From a console keypad,

press * to continue. The ENTER

DEVICE NO. prompt will appear.

From a telephone keypad, enter 00 to exit, or enter the next

relay number to be programmed. The current on/off state of that relay

will be annunciated as described above. Alternatively, if 6 seconds

elapses with no key depression, the voice module will annunciate the

“ENTER DEVICE CODE NOW message.

-34-

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 65 66

Keine Kommentare

ADEMCO VISTA-5OUL Betriebsanweisung Seite 34