ADEMCO 4120XM Spezifikationen PDF herunterladen (Seite 35)

TESTING THE SYSTEM

Motion Detectors: Walk in front of any interior motion detectors (if used)

and listen for 3 tones as movement is detected. The identification of the

detector should also be displayed when the motion detector is activated.

Smoke Detectors: Follow the manufacturer’s instructions to test all smoke

detectors to ensure that all are functioning properly. The identification of

each detector should also be displayed when each is activated.

8. Personal Emergency Wireless Transmitter (if used in your system): Take

your personal emergency transmitter(s) where you are most likely to use it.

When testing the emergency transmitter, you should be no farther than

150 feet from the control cabinet, whether you are indoors or outdoors.

Press and hold the Jarge button on the transmitter for at least 2

seconds. The console will emit 3 tones and display the number 62 or 63.

Release the button on the transmitter. The Control will Droduce 3 tones

and the display will turn off.

If no tones are heard after the emergency transmitter’s test button has

been pressed, the transmitter may be inoperative or the particular

location where it is being tested may have a poor signal path to the

control. Try other locations in the same general area.

9. When all protection points have been checked, there should be no zone

identification numbers displayed. If a problem is experienced with any

protection point (no confirming sounds, no display),

CALL FOR SERVICE.

10. Turn off Test mode by entering the security code and pressing the OFF

key.

-35-

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 59 60

Keine Kommentare

ADEMCO 4120XM Spezifikationen Seite 35