ADEMCO VISTA-120 Betriebsanweisung Seite 11

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 58
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 10
– 11 –
CHECKING FOR OPEN ZONES
Using the
READY Key
Before arming your system, all protected doors, windows and
other protection zones should be closed or bypassed (see
BYPASSING section). Otherwise the keypad will display a "Not
Ready" message. Using the READY key will display all zones
that are faulted, making it easier for you to secure any open
zones.
Note that your installer can set up your system to allow you to
arm the system even though an exit route is faulted at the time
of arming. The exit route must be closed by the time the exit
delay expires, or the system will go into alarm.
The installer can also program your system to NOT go into alarm
if an exit route is still open at the end of the normal exit delay time,
but instead will automatically bypass the faulted zone and arm
the rest of the system. This may prevent false alarms when
people are slow to close an exit route door(s).
Check with your installer to determine the options programmed in
your system.
To show faulted zones:
DISARMED - PRESS
TO SHOW FAULTS
Note: Keypads also light a green LED if all
protection zones are secure. If not lit, the
system can only be armed if the zones that
are NOT READY are on the exit route.
Otherwise, zones that are NOT READY must
be made secure or bypassed.
READY
1. Do not enter security code, but simply press key.
FAULT 005 FRONT
UPSTAIRS BEDROOM
Typical fault display
2.
DISARMED
READY TO ARM
The "Ready" message will be displayed
when all protection zones have been
either closed or bypassed.
NOTE: All or part of this message may be
replaced by a customised message
programmed by the installer. Bear this in mind
whenever the instructions indicate that the
"DISARMED" or "READY" message will be
displayed.
Seitenansicht 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 57 58

Kommentare zu diesen Handbüchern

Keine Kommentare