VISTA-20HWSE2-PARTITIONEDSECURITY SYSTEMPROGRAMMINGFORM®Principal changes between the VISTA-20HWSE andthe former VISTA-20HW are indicated by margin li
– 2 –Local programming requires the use of a 2-line Alpha keypad connected topartition 1 keypad terminals on the control.NOTE: For UL installations, t
– 3 –*37 AUDIBLE EXIT WARNING [1] [1]Part. 1 †Part. 2 † 0 = no; 1 = yes*38 CONFIRMATION OF ARMING DING [0] [0]Part. 1 †P
– 4 –*49 SPLIT/DUAL REPORTING [0]0 = Disable (Backup report only)TO PRIMARY PHONE No. TO SECONDARY PHONE No.1 = Alarms, Restore, Cancel Others2
– 5 –EXPANSION ZONES: Assign zone numbers (Zn) 10–17 to 4219/4229 Auxiliary Wired Loops A–H, if used.ZONE ZONE ZONE PART'N ALARM RPT CODE INPUTDE
– 6 –OUTPUT AND SYSTEM SETUP (*80–*93)*80 OUTPUT RELAYS AND POWERLINE CARRIER DEVICESProgram only if Relays and/or Powerline Carrier devices are to be
– 7 –OUTPUT RELAYS/POWERLINE CARRIER DEVICES WORKSHEET FOR *80, and *81.Applicable only if Relays and/or Powerline Carrier Devicess are to be used.*80
*81 ZONE LISTS FOR OUTPUT DEVICES – This is an interactive mode. Fill in the required data on the worksheetbelow and follow the procedure in the insta
Kommentare zu diesen Handbüchern