ADEMCO LYNXR24 Einstellungsanleitung PDF herunterladen (Seite 8)

- 8 -

✱

RF XMTR LO BAT RST RPT CODE

[1,0]

✱

TEST RESTORE RPT CODE

[0,0]

OUTPUT AND SYSTEM SETUP (

80–

92)

✱

DEVICE PROGRAMMING MENU

MODE

ZONE LISTS MENU MODE

Program *80 and *81 only if Powerline Carrier Devices or chime

by zone are to be used. See procedure later in this manual.

✱

ENHANCED SEQUENTIAL MODE See procedure later in this manual.

✱

ASSIGN ZONE VOICE

DESCRIPTOR

See procedure later in this manual.

✱

RECORD CUSTOM VOICE

DESCRIPTOR

See procedure later in this manual.

✱

AUX FUNCTION/ 1-BUTTON

PAGING

[0]

0 = Aux key performs defined function (macro);

1 = Aux key sends message (999-9999) to pager

If 1, you must also select an option 6-9 in field *49.

✱

PAGER CHARACTERS

Up to 16 digits can be entered that will appear in front of the 7-digit

pager message sent by the control (either upon system event or upon

pressing AUX key [if programmed for paging]; see field *87 and *49 for

other options regarding the paging feature). See the Installation

Instructions (fields *87, *88 and *49) for full descriptions of the paging

feature. You do not need to fill all 16 digits (press [*] to advance to

next field). To clear entries, enter *88*.

To enter “*” = [#] + [11]; To enter “#” = [#] + 12]

To enter 2-second pause = [#] + [13] (some pagers require an

additional delay [pause] in order to receive the entire message)

✱

EVENT LOG 80% FULL RPT CODE

[0,0]

✱

EVENT LOGGING

[3]

0 = None; 1 = Alarm/Alarm Restore; 2 = Trouble/Trouble Restore;

4 = Bypass/Bypass Restore; 8 = Open/Close.

Example:

To select “Alarm/Alarm Restore”, and “Open/Close”, enter 9

(1 + 8); To select all, enter #15.

Note:

System messages are logged when any non-zero selection is made.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Kommentare zu diesen Handbüchern

Keine Kommentare

ADEMCO LYNXR24 Einstellungsanleitung Seite 8

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme ADEMCO LYNXR24